Manual

6
ADDING LAUNDRY PRODUCTS
Adding HE detergent to basket:
Single-dose laundry packets, Oxitype boosters, color-safe
bleach, or scented crystals can be added to the drum prior
to adding laundry. When using
single-dose laundry packets, make
sure that the Load & Go™ Bulk
Dispenser option is disabled.
NOTE: Follow the manufacturer’s
instructions to determine the
amount of laundry products to use.
Adding liquid chlorine bleach to single-load dispenser:
Add liquid chlorine bleach
to the bleach compartment.
Do not overll, dilute, or use
more than 2/3 cup (165 mL).
Do not use color-safe bleach
or Oxi in the same cycle with
liquid chlorine bleach.
IMPORTANT:
n Always measure liquid chlorine bleach. Use a measuring
cup with a pour spout; do not guess.
n Do not ll beyond the “MAX” line. Overlling could cause
garment damage.
n Do not use thickened, easy-pour, or no-splash bleach
when running the Clean Washer with affresh
®
cycle, as
excess suds may occur.
n Do not add liquid chlorine bleach to the bulk dispenser.
n Slowly close dispenser drawers. Make sure the drawers
are closed completely.
Adding liquid fabric softener to single-load dispenser:
Pour a measured amount of
liquid fabric softener into liquid
fabric softener compartment.
Always follow manufacturer’s
directions for correct amount
of fabric softener, based on
your load size. Fabric softener
is always dispensed in the last
rinse.
IMPORTANT: Do not overll, dilute, or use more than the
manufacturer-recommended quantity of fabric softener. Do not
ll past the “MAX” line. Overlling dispenser will cause fabric
softener to immediately dispense into machine.
n Do not spill or drip any fabric softener onto the clothes.
n Do not use liquid fabric softener dispenser balls in this
machine. They will not dispense correctly.
n Do not use fabric softener sheets, as they can stain the
load.
Adding HE detergent to Load & Go™ dispenser:
Use only High Efficiency (HE) liquid detergents. The bulk
dispensers will hold about 67.6 oz. (2 L) of liquid HE detergent,
depending on dispenser, or enough for many loads of laundry.
To fill bulk dispensers:
Open the dispenser drawer by pulling
on the handle at the base of the
machine. If desired, the drawer can
be completely removed from the
machine.
Locate the Load & Go™ bulk
dispenser. Gently pull up on the tab
located on the bulk dispenser lid to lift
the ll door.
Fill to the “MAX” line (see illustrations
at right) with HE liquid detergent.
Close ll door. It will click into place.
Make sure the concentration setting is
correct. (see the Cycle Guide)
It is recommended that you rinse out the Load & Go™
containers when relling, when changing detergent types or
concentrations, or when they will not
be used for an extended period. For
instructions on cleaning the dispenser
cartridge, see “All-In-One Washer
Dryer Maintenance and Care” section.
When you want the machine to use
the Load & Go bulk dispenser for
automatic detergent dispensing,
make sure that the Load & Go™ bulk
dispenser option is enabled. Also, do
not add any detergent to the single-
load dispenser.
Adding HE detergent to single-load dispenser:
Pour a measured amount of HE detergent into detergent
compartment. For powdered detergent, lift the selector to the
high position. For liquid detergent,
push down the selector to the low
position. Do not overll; adding too
much detergent may cause detergent
to be dispensed into the machine
too early. When using single-dose
dispenser for detergent, make sure
that the Load & Go™ bulk dispenser option is disabled.
Getting the most out of your All-In-One Washer Dryer:
Your new machine is congured to run wash cycles by default.
You also have the option to run Wash & Dry cycles or Dry Only
cycles.
For optimal drying results and to avoid wrinkling of clothes,
do not load clothes more than half full. Since this unit uses a
ventless drying technology, expect longer dry times compared to
a vented Washer Dryer.
Ta b
Selector
HE detergent
compartment
“Max” line