Manual

ManualsBrandsWhirlpool ManualsLaundry centerOfficial Whirlpool stacked laundry center

ALL-IN-ONE WASHER DRYER

MAINTENANCE AND CARE

Water Inlet Hoses

Replace inlet hoses after ve years of use to reduce the risk of

hose failure. Periodically inspect and replace inlet hoses if bulges,

kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses:

Mark the date of replacement on the label with a permanent

marker.

Check that the old rubber seals on water inlet hoses are not stuck

on the machine inlet valves.

Use new washers in the new inlet hoses to ensure a proper seal.

All-In-One Washer Dryer Care

Recommendations to Help Keep Your Machine Clean and

Performing at Its Best

1. Always use High Efciency (HE) detergents and follow the

HE detergent manufacturer’s instructions regarding the

amount of HE detergent to use. Do not use more than the

recommended amount because that may increase the rate

at which detergent and soil residue accumulate inside your

machine which, in turn, may result in undesirable odor.

2. Use warm or hot water washes sometimes (not exclusively

cold water washes) because they do a better job of

controlling the rate at which soils and detergent accumulate.

3. Always leave the machine door slightly ajar between uses

to help dry out the machine and avoid the buildup of odor

causing residue.

4. Periodically clean residue from all interior surfaces of the

window. For better care, wipe the entire inside of the door

with a damp cloth.

Cleaning Your All-In-One Washer Dryer

Read these instructions completely before beginning the

routine cleaning processes recommended below. This machine

maintenance procedure should be performed, at a minimum, once

per month or every 30 cycles, whichever occurs sooner, to control

the rate at which soils and detergent may otherwise accumulate in

your machine. Note that since this is an all-in-one Washer Dryer

without a lint screen, you may see some more lint accumulation

on the door seal than a typical washer.

Cleaning the Door Seal

1. Open the machine door and remove any clothing or items

from the machine.

2. Inspect the gray-colored seal between the door opening and

the drum for stained areas, soil buildup, or lint. Pull back

the seal to inspect all areas under the seal and to check for

foreign objects or lint.

3. If stained areas, soil buildup, or lint are found, wipe down

these areas of the seal using either of the following two

procedures:

a. Affresh

Machine Cleaning Wipes Procedure:

i. When the cycle is complete, gently pull back the

rubber door seal and clean the entire surface with

the textured side of an affresh

Machine Cleaning

Wipe.

b. Dilute Liquid Chlorine Bleach Procedure:

i. Mix a dilute bleach solution, using 3/4 cup (177 mL)

of liquid chlorine bleach and 1 gallon (3.8 L) of warm

tap water.

ii. Wipe the seal area with the dilute solution, using a

damp cloth.

iii. Let stand for 5 minutes.

iv. Wipe down area thoroughly with a dry cloth and let

machine interior air dry with door open.

IMPORTANT:

n Wear rubber gloves when cleaning with bleach.

n Refer to the bleach manufacturer’s instructions for proper

use.

Cleaning the Inside of the All-In-One Washer Dryer

This machine has a special cycle that uses higher water volumes

in combination with affresh

Washer Cleaner or regular liquid

chlorine bleach to thoroughly clean the inside of the machine.

Steam models also utilize steam to enhance cleaning in this

special cycle.

IMPORTANT: Do not use thickened, easy-pour, or no-splash

bleach when running the Clean Washer with affresh

cycle as

excess suds may occur.

NOTE: Read these instructions completely before beginning the

cleaning process.

Begin procedure

1. Clean Washer with affresh

Cycle Procedure

(Recommended for best performance):

a. Open the machine door and remove any clothing or

items.

b. Use an affresh

Machine Cleaning Wipe or a soft, damp

cloth or sponge to clean the inside door window.

c. Add an affresh

Washer Cleaner tablet to the machine

drum.

d. Do not add the affresh

Washer Cleaner tablet to the

dispenser drawer.

e. Do not add any detergent or other chemical to the

machine when following this procedure.

f. Close the machine door.

g. Select the Clean Washer with affresh

cycle.

h. Select the FanFresh

option to help dry the machine

interior after the cycle is complete.

NOTE: The machine remembers your last option

selection and will use it for future wash cycles until you

deselect that option.

i. Touch and hold START/PAUSE to begin the cycle. The

Clean Washer with affresh

cycle operation is described

below.

2. Chlorine Bleach Procedure:

a. Open the machine door and remove any clothing or

items.

b. Open the single load dispenser drawer and add

regular liquid chlorine bleach to the “MAX” line in

both the bleach compartment and the fabric softener

compartment. Either traditional or HE chlorine bleach

can be used.

IMPORTANT: Do not use thickened, easy-pour, or no

splash bleach as excess suds may occur.

NOTE: Use of more liquid chlorine bleach than is

recommended above could cause machine damage

over time.

c. Close the machine door and the dispenser drawer.

d. Do not add any detergent or other chemicals to the