Specifications

GAS CONVERSIONS
Explosion Hazard
Use a new CSA _nternationam approved gas supply line.
Install a shut=off valve°
Securemy tighten aH gas connections.
if connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
comumn°
Examples of a qualifiedperson incmude:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Remove storage drawer or warming drawer. Locate gas
pressure regulator at rear of storage or warming drawer
compartment.
NOTE: On models with a warming drawer, an access cover
must be removed from the gas pressure regulator.
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
Gas pressure regulator
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a
%" combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
Side viewbefore
A
Tip Over Hazard
A child or adumt can tip the range and be killed.
Connect anti=tip bracket to rear range foot,
Reconnect the anti-tip bracket, if the range is moved,
Faimure to follow these instructions can result in death
or serious burns to chimdren and adumts,
To Convert Gas Pressure Regulator
1. Turn the manual shutoff valve to the closed position.
Unplug range or disconnect power.
..........................B
A
.............C
A. Torange
B. Manual shutoff valve "closed" position
C. Gassupply line
B
/
C Side view after
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C.Gas pressure regulator cap with hollow end facing out
D.Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
"<- LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Standard Surface Burners
1. Remove burner cap.
2. Using a Phillips or Quadrex ®screwdriver, remove the burner
base.
12