Use & care guide

Moving the range:
When moving range, slide range onto
cardboard or hardboard to prevent
damaging the floor covering.
If removing the range is necessary for
cleaning or maintenance:
1. Shut off the gas supply to the range.
2. If necessary, slide range forward, away
from the wall, just far enough to
disconnect the gas supply line.
3. Slide range forward to complete
cleaning or maintenance.
Tip Over Hazard
A child or adult can tip the range
and be killed.
Connect anti-tip bracket to rear
range foot.
Reconnect the anti-tip bracket, if
the range is moved.
Failure to follow these instructions
can result in death or serious
burns to children and adults.
WARNING
anti-tip
bracket
range foot
4. Making sure the anti-tip bracket is
installed:
• Look for the anti-tip bracket securely
attached to floor.
• Slide range back so rear range foot is
under anti-tip bracket.
5. Check that range is level.
6. Reconnect gas line to range and check
for leaks.
10
7. Locate selector key on oven
thermostat and turn counterclockwise to
the Natural position.
8.Turn manual shutoff valve in gas
supply line on. If “Gas connection” Steps
10-17 on Pages 5-6 were not completed,
complete them now.
9. Light the burner pilots. See Step
15, Page 6. Adjust the pilot flame as
shown in Step 15b. NOTE: This must be
done after conversion is completed.
10. Light the oven burner pilot.
11. Install control knobs. Complete
"Check operation" section, Steps 18-23,
Page 7. Check for proper flame. Natural
gas flames do not have yellow tips.
12. Close broiler door. Turn oven
control knob to “OFF”.
13. Remove control knobs.
Reinstall the control panel. Securely
tighten the 4 screws. Reinstall the control
knobs. ( The oven control is the center
knob.)
Important: If not done in Step 9, check the
“LO” flame adjustment. See "Check
operation" section, Step 20, Page 7.
L
P
N
A
T
thermostat
gas
manifold
selector
key
c. Use a 3/8” combination wrench and
remove the L.P. gas orifice spud. Install
the number “47” Natural gas spud.
Place L.P. gas oven burner spud in plastic
parts bag along with L.P. gas cooktop
burner spuds for future use and keep
with literature package.
d. Reinstall the oven burner.