Use & care guide

3
Parts supplied for
installation:
Product
dimensions
(Bracket must be securely mounted to
sub-floor. Thickness of flooring may require
longer screws to anchor the bracket to
sub-floor.)
anti-tip bracket
2 screws (#10 x 1-1/2")
2 plastic anchors
Not shown:
• literature pack
• orifice spuds
Contact a qualified
floor covering
installer to check
that the floor
covering can
withstand at least
200°F.
Use an insulated
pad or 1/4" plywood
under range if
installing range over
carpeting.
For minimum
clearance to top of
cooktop, see Note.***
Do Not seal the range to
the side cabinets.
If cabinet depth is greater
than 24", oven frame
must extend beyond
cabinet fronts by 1/2"
min.
18" min.
clearance
upper
cabinet to
countertop
13" max. upper
cabinet depth
30-1/8"
opening
width
30" min. cabinet
opening width
8"
2"
5"
10"
2" min. countertop
space to side wall or
other combustible
material
This shaded area
recommended
for installation
of gas pipe.
29-7/8" width
46-1/4"
overall height for
tall backguard
models
24-1/4"
36"
cooktop
height
26-3/4" depth
with handle
Proper gas supply
connection must be
available. See “Gas
supply requirements,“
Page 4.
Cutout dimensions/requirements
*** Note: 24" min. when bottom of wood or metal
cabinet is protected by not less than 1/4"
flame retardant millboard covered with not
less than No. 28 MSG sheet steel, 0.015"
stainless steel, 0.024" aluminum or 0.020"
copper.
30" min. clearance between the top of the
cooking platform and the bottom of an
unprotected wood or metal cabinet.
Check location where range will be installed. The
range should be located for convenient use in the
kitchen. Recessed installations must provide
complete enclosure of the sides and rear of range.
ALL OPENINGS IN THE WALL OR FLOOR WHERE
RANGE IS TO BE INSTALLED MUST BE SEALED.
IMPORTANT: Some cabinet and building materials are
not designed to withstand the heat produced by the
oven for baking and self-cleaning. Check with your
builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain
other damage.
The floor anti-tip
bracket MUST be
installed. To install
the anti-tip bracket
shipped with the
range, see Page 7
and the anti-tip
bracket template.
Anti-tip bracket: