Instruction for Use

14
GB
Using the hob
Lighting the burners
For each BURNER knob there is a complete ring showing
the strength of the flame for the relevant burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an anticlockwise
direction so that it is pointing to the maximum flame
setting .
3. Adjust the intensity of the flame to the desired level by
turning the BURNER knob in an anticlockwise direction.
This may be the minimum setting , the maximum setting
 or any position in between the two.
If the appliance is fitted with an electronic lighting
device*(D) (see  gure), press
the ignition button, marked with
the symbol
, then hold the
BURNER knob down and turn
it in an anticlockwise direction,
towards the maximum flame
setting, until the burner is lit.The
burner may be extinguished
when the knob is released. If
this occurs, repeat the operation, holding the knob down
for a longer period of time.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.
If the appliance is equipped with a flame failure safety
device*(X), press and hold the BURNER knob for
approximately 3-7 seconds to keep the flame alight and
to activate the device.
To switch the burner off, turn the knob until it reaches the
stop position
•.
Practical advice on using the burners
For the burners to work in the most efficient way possible
and to save on the amount of gas consumed, it is
recommended that only pans that have a lid and a flat
base are used. They should also be suited to the size of
the burner.
To identify the type of burner, please refer to the diagrams
contained in the “Burner and nozzle specifications”.
Start-up and use
! On the models supplied with a reducer shelf, remember
that this should be used only for the auxiliary burner when
you use casserole dishes with a diameter under 12 cm.
Using the oven
! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening the
oven door. The appliance may emit a slightly unpleasant
odour caused by protective substances used during the
manufacturing process burning away.
! Never put objects directly on the bottom of the oven; this
will avoid the enamel coating being damaged. Only use
position 1 in the oven when cooking with the rotisserie
spit.
Lighting the oven
To light the oven burner, bring
a flame or gas lighter close to
opening F (see  gure) and press
the OVEN control knob while
turning it in an anticlockwise
direction until it reaches the MAX
position.
If the appliance is fitted with an
electronic lighting device* (see figure), press the ignition
button, marked with the symbol
, then hold the OVEN
control knob and turn it in an anticlockwise direction,
towards the MAX position, until the burner is lit. If, after
15 seconds, the burner is still not alight, release the knob,
open the oven door and wait for at least 1 minute before
trying to light it again. If there is no electricity the burner
may be lit using a flame or a lighter, as described above.
! The oven is fitted with a safety device and it is therefore
necessary to hold the OVEN control knob down for
approximately 6 seconds.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight the oven.
* Only available in certain models.
X
D
F