Manual

9. Plug into a grounded 3 prong outlet.
10. Press RESET on the power supply cord.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
AIR CONDITIONERUSE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn the air conditioner off, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
FILTER Timer
MODE Auto Cool FanOnly Power
Saver
NOTES:
• When the air conditioner is off, the Room indicator light is lit
and the display shows the current room temperature.
• If the room temperature is below 55°F (13°C), the display will
show 55°F (13°C). If the room temperature is above 99°F
(37°C), the display will show 99°F (37°C).
1.
2.
When the Set indicator light is lit, the display shows the
temperature control setting. See "Temperature."
When the Hour indicator light is lit, the display shows the time
remaining on the Timer setting. See "Timer Delay."
Remove clear protective film from control panel and front
panel badge (on some models).
Press POWER to turn on air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
1=
2.
Press MODE until you see the indicator light come on for the
setting you desire.
Choose Auto, Cool, Fan Only or Power Saver.
• Auto--Cools room while it automatically controls fan
speed. You cannot change fan speed, but you can adjust
temperature by pressing the plus or minus button.
• Cool--Cools room. You can adjust temperature by
pressing the plus or minus button. You can select fan
speed by pressing FAN SPEED.
• Fan Only--Only the fan runs. You can select the fan
speed by pressing FAN SPEED, but you cannot adjust the
Temperature control setting. Display shows the current
room temperature.
12