Manual

Thermostat
Turn the THERMOSTAT control to a mid-setting. Adjust the air
conditioner's performance by turning the Thermostat control
clockwise for maximum cooling. For less cooling, turn the
THERMOSTAT control counterclockwise. Experiment to find the
setting that suits you best.
_THERMOSTAT
Style 2--Heat/cool air conditioner settings
(on some models)
Fan Control
Set FAN control to the desired setting. When the air conditioner is
operating at Low Cool, High Cool, Turbo Cool, Low Heat or Turbo
Heat, the fan circulates air continuously.
• Turbo Cool--for maximum cooling
• High Cool--for normal cooling
• Low Cool--for sleeping comfort
• Turbo Heat--for maximum heating
• Low Heat--for reduced heating
• Fan Only--to move air continuously without cooling or
heating
NOTE: Fan runs on Turbo speed only.
• Power Saver--fan runs only when cooling is needed.
Since the fan does not circulate the room air continuously,
less energy is used, but the room air is not circulated as
often. Use Power Saver when you are asleep or away
from home.
NOTE: Fan runs on Low speed only.
_FAN CONTROL
Thermostat
Turn the THERMOSTAT control to a mid-setting. Adjust the air
conditioner's performance by turning the Thermostat control
clockwise for maximum cooling. For less cooling, turn the
THERMOSTAT control counterclockwise. Experiment to find the
setting that suits you best.
For heating, turn the THERMOSTAT control counterclockwise.
The electric-strip heater is activated when the Fan Control is set
to a heat setting.
NOTE: Your air conditioner is not designed to be used as a
primary heat source. It is intended for supplemental heating only.
_ THERMOSTAT
Use the tabs to direct the air right, left or straight ahead (on some
models). Rotate the whole cartridge to direct air up, down or
straight ahead.
A
B
A. Tabs
B. Cartridges
When your air conditioner is operating normally, you may hear
sounds such as:
• Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
• Air movement from the fan.
• Clicks from the thermostat cycle.
• Vibrations or noise due to poor wall or window construction.
• A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
16