Users Guide Installation & Servicing Model ACG 900 IX NOTE TO INSTALLER: LEAVE THE OWNER’S GUIDE MANUAL WITH THE APPLIANCE.
WHEN YOU CALL FOR SERVICE Costumer Service: 1300 363 344 Service call booking: 1300 361 166 RECORD HERE FOR EASY REFERENCE Model Serial Number Colour Whirlpool Europa S.r.l. Viale G. Borghi, 27 21025 Comerio (VA) Italy Installation Date Dealer's Name and Address When you call for service or order parts for your unit, be sure to give: 1. MODEL 2. SERIAL NUMBER 3. COLOUR 4. PART NAME and/or description of problem 5.
I N S TA L L AT I O N PROVISION FOR VENTILATION The room where the Cooker is installed should have permanent ventilation as follows: “Ventilation must be in accordance with AS5601/AG 601 - Gas Installations. In general, the appliance should have adequate ventilation for complete combustion of gas, proper flueing and to maintain temperature of immediate surroundings within safe limits.” - Do not install in a bed-sitting room, a bathroom or shower room.
GAS CONVERSION AND ADJUSTMENT When used with natural gas all burners have been preset at our factory and further adjustment should not be necessary. Conversion kits to other gases are available from the place of purchase. Do not attempt to fit the conversion kit yourself. Conversion to U-LPG gas should only be carried out by an authorized technician. GAS CONNECTION Should conform to gas utility regulations e.g. AS5601 Gas installations; also refer to rangehood manufacturers recommendations.
- change the injector (see Fig. 1A) and replace it with another one suitable for the new type of gas (see tab. 1) 2nd SECTION FOR THE USER WARNING: Children should be kept away while the oven or grill is in use since accessible parts become hot. Fig. 1A MINIMUM FLOW ADJUSTMENT FOR HOB-TOP TAPS In order to adjust the minimum flame setting proceed as follows: switch the burner on, and set the knob at the minimum position .
The small flame indicates the ‘low position’. Turn the knob to it after the contents of a pan have boiled. - 1 Minute Tour Be safe Please read the rest of the instruction book which contains important information to help you use the appliance safely and efficiently. Gas and Electricity on Make sure that the gas supply is turned on and that the appliance is plugged in and switched on. The ignitor needs electricity. In case there is no electric current, the burner can also be lighted using a match.
HOW TO USE YOUR ELECTRIC OVEN When you turn the control knob to this position, the light will be on for all the following operations. - Before cooking in the first time we reccommend that the oven should be operated at 200° C for 30 minutes to remove any manufacturing greases and odours. - Do not place items or pan directly on to the oven botton. - Foil should only be used to cover food and not oven shelves or party of the oven.
conventional oven, using one tray only. Cooking results are a matter of personal preference and may easily be adjusted to suit individual requirements by slight adjustment of the temperature and or cooking time. Preheating of the oven is recommended for 10-15 minutes or until the oven thermostat indicator light switches off to show the selected temperature has been reached.
USE OF THE ELECTRIC GRILL CLEANING USlNG THE GRILL Turn the oven knob to the right and place it on the grill position . The grill pan should be located on the top oven shelf position and is provided with a detachable grill pan handle which is engaged centrally over the front edge of the pan between the indentations provided. A wire grid is supplied.
SERVICE INSTRUCTIONS IMPORTANT Do not use excessive water when cleaning the oven and avoid water passing through the fan grill or ducts in the oven back . Avoid letting grease deposit collect around the upper heating element: it will cause smoking and may start a fire. Fig. 6 All service should be carried out be a authorised service technician only.
DISASSEMBLE OF WORK-TOP In case it is necessary to repair or replace the inside components, act as follows: Remove the grids, remove burners and flame-spreaders (see fig. 13), unscrew the visible screws “V” placed on the work-top (see fig. 14). Disassemble the work-top by unscrewing the rear screws “A” (see fig. 15). In this way it is possible to lift the worktop and to reach the inside components. SOME SAFETY POINT Do not use the appliance as a space heater. If you smell gas Open a window.
OVEN DOES NOT WORK AT ALL First, when the oven is equipped with timer, check appliance is not programmed to turn on later. If it is, turn to manual setting (i.e. hand symbol). If the button or scale on the timer remains in the automatic position after use, the power supply to the oven will be interrupted. Also, check your appliance is switched on at the mains. Next check for an unexpected power strike by switching on adjacent lights etc. Finally, check fuses and plug wiring.
Users Guide Installation & Servicing Model ACG 900 IX NOTE TO INSTALLER: LEAVE THE OWNERS GUIDE MANUAL WITH THE APPLIANCE.
WHEN YOU CALL FOR SERVICE Costumer Service: 1300 363 344 Service call booking: 1300 361 166 RECORD HERE FOR EASY REFERENCE Model Serial Number Colour Whirlpool Europa S.r.l. Viale G. Borghi, 27 21025 Comerio (VA) Italy Installation Date Dealer's Name and Address When you call for service or order parts for your unit, be sure to give: 1. MODEL 2. SERIAL NUMBER 3. COLOUR 4. PART NAME and/or description of problem 5.
I N S TA L L AT I O N Clearances to non- combustible materials PROVISION FOR VENTILATION The room where the Cooker is installed should have permanent ventilation as follows: Ventilation must be in accordance with AS5601/AG 601 - Gas Installations. In general, the appliance should have adequate ventilation for complete combustion of gas, proper flueing and to maintain temperature of immediate surroundings within safe limits. - Do not install in a bed-sitting room, a bathroom or shower room.
the characteristics of the gas and electricity output. The appliance is generally preset for natural gas (so no other adjustment is necessary) ensure regulator is fitted for N.G. Ensure that all foreign matter has been cleared from the gas supply line and also purge all air from the gas system. Connect to regulator, tighten and check the installation to ensure no gas leaks occur.
- change the injector (see Fig. 1A) and replace it with another one suitable for the new type of gas (see tab. 1) 2nd SECTION FOR THE USER WARNING: Children should be kept away while the oven or grill is in use since accessible parts become hot. Fig. 1A MINIMUM FLOW ADJUSTMENT FOR HOB-TOP TAPS In order to adjust the minimum flame setting proceed as follows: switch the burner on, and set the knob at the minimum position .
- 1 Minute Tour - The small flame indicates the low position. Turn the knob to it after the contents of a pan have boiled. Be safe Please read the rest of the instruction book which contains important information to help you use the appliance safely and efficiently. Gas and Electricity on Make sure that the gas supply is turned on and that the appliance is plugged in and switched on. The ignitor needs electricity. In case there is no electric current, the burner can also be lighted using a match.
HOW TO USE YOUR ELECTRIC OVEN When you turn the control knob to this position, the light will be on for all the following operations. - Before cooking in the first time we reccommend that the oven should be operated at 200° C for 30 minutes to remove any manufacturing greases and odours. - Do not place items or pan directly on to the oven botton. - Foil should only be used to cover food and not oven shelves or party of the oven.
conventional oven, using one tray only. Cooking results are a matter of personal preference and may easily be adjusted to suit individual requirements by slight adjustment of the temperature and or cooking time. Preheating of the oven is recommended for 10-15 minutes or until the oven thermostat indicator light switches off to show the selected temperature has been reached.
USE OF THE ELECTRIC GRILL CLEANING USlNG THE GRILL Turn the oven knob to the right and place it on the grill position . The grill pan should be located on the top oven shelf position and is provided with a detachable grill pan handle which is engaged centrally over the front edge of the pan between the indentations provided. A wire grid is supplied.
SERVICE INSTRUCTIONS IMPORTANT Do not use excessive water when cleaning the oven and avoid water passing through the fan grill or ducts in the oven back . Avoid letting grease deposit collect around the upper heating element: it will cause smoking and may start a fire. Fig. 6 All service should be carried out be a authorised service technician only.
DISASSEMBLE OF WORK-TOP In case it is necessary to repair or replace the inside components, act as follows: Remove the grids, remove burners and flame-spreaders (see fig. 13), unscrew the visible screws V placed on the work-top (see fig. 14). Disassemble the work-top by unscrewing the rear screws A (see fig. 15). In this way it is possible to lift the worktop and to reach the inside components. SOME SAFETY POINT Do not use the appliance as a space heater. If you smell gas Open a window.
OVEN DOES NOT WORK AT ALL First, when the oven is equipped with timer, check appliance is not programmed to turn on later. If it is, turn to manual setting (i.e. hand symbol). If the button or scale on the timer remains in the automatic position after use, the power supply to the oven will be interrupted. Also, check your appliance is switched on at the mains. Next check for an unexpected power strike by switching on adjacent lights etc. Finally, check fuses and plug wiring.
