Instruction for Use

INSTRUCTIONS FOR THE INSTALLER
MAINTENANCE
Prior to any maintenance work or changing
parts, disconnect the appliance from the gas and
electricity power sources.
REPLACING THE TAPS AND THERMOSTAT (g. 23)
To change a tap or the thermostat proceed as follows:
• Remove pan supports, burner heads and knobs.
• Unscrew the burners securing screws.
• Remove the lateral sides, lid and hob.
• Unscrew the check nuts of rails (D) and/or of any
thermocouples and remove tap (R) or the thermostat
(T) by unscrewing the screws (V).
• Partly remove the burners small supply pipes and
change the relative part.
• Replace the seal (G) each time you change a tap or
thermostat so as to guarantee a perfect t between
body and rail.
• Reassemble all the parts following the same
procedure but in the reverse order.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will nd printed on it.
REPLACING THE ELECTRICAL COMPONENTS
• The rear protection will have to be removed in order
to change the electrical heating elements, lamp
holder, terminal board and power cable.
• If you have to change the power cable, always
keep the earth wire longer than the phase wires
and, in addition, follow all the instructions given
in the “ELECTRICAL CONNECTION” paragraph.
• To replace the oven lamp please refer to instructions
on REPLACING THE OVEN LAMP paragraph.
• To change the lamp-holder (P) (g. 24), force the
tabs of blockage (M) and take the lamp-holder
toward the outside of the oven.
• To replace the ignition generator, remove the left
side panel of the appliance.






23


24
242424
24