Instruction for Use

26
INSTRUCTIONS FOR THE INSTALLER
MAINTENANCE
Prior to any maintenance work or changing
parts, disconnect the appliance from the
gas and electricity power sources.
REPLACING THE TAPS AND THERMOSTAT
Proceed in the following way when replacing a
tap or the thermostat:
• Remove pan supports, burner heads.
• Unscrew the burner xing screws (Vc) (g.
25). (four for ultrarapid burner and two for the
other burners)
• Remove the hob, unscrewing frontal and
rear xing screws (Vs) (g. 25) which lock the
hob at the supports (S).
• Pull out the knobs.
• Unscrew the nuts (D) of the gas aluminium
pipes and pull out the thermocouple quick
connectors (F) (g. 27).
• Unscrew the screws (Vt) (g. 26) which lock
the crosspieces.
• Unscrew the screws (Vb) (g. 26) which unite
the the bridles of the taps to the front frame.
• Make to slip the ramp toward the back part
and unscrew the screws (Vb) (g. 27) in order
to free the taps.
• Change seal each time a tap or a thermostat
is replaced. This will ensure perfect retention
between the tap or a thermostat and part.
Vs
S
Vs
S
25
Vt
Vt
Vb
26
D
F
Vb
27
• Reassemble all the parts following the same
procedure but in the reverse order.