Instruction for Use

27
INSTRUCTIONS FOR THE INSTALLER
ELECTRICAL CONNECTION
The electrical connection must be carried
out in accordance with the current
standards and laws in force.
B
efore connecting check that:
• The system and electrical sockets amperage
is adequate for the appliance maximum
power (see data label axed on the back of
the cooker).
• The socket or system has an eective earth
connection in accordance with current
standards and prescriptions of the law. All
responsibility is disclaimed if this is not
complied with.
• The plug and socket or the multipolar switch
must be accessible after installation of the
appliance.
When connecting to the mains with a socket
• Fit to the power cable (if without) a
standardized plug, suitable for the load
which is indicated on the data label. Connect
the wires making sure they correspond
as shown below, and remember that the
earth wire must be longer than the phase
wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
(earth) = green/yellow wire
• The power cable must be laid so that no
parts of it ever reach a temperature of 75 °C.
• For connecting do not use, adapters or
shunts as they could cause false contacts
resulting in hazardous overheating.
When connecting directly to the mains:
• Install a multipolar switch that can withstand
the appliance load, with a minimum opening
between the contacts of 3 mm.
• Remember that the earth wire must not be
cut out by the switch.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always
in excellent condition we strongly recommend
changing it on the date you will nd printed on
it.
REPLACING THE ELECTRICAL
COMPONENTS
• The rear protection will have to be removed
in order to change the electrical heating
elements, spit motor, terminal board and
power cable.
• If you have to change the power cable (see
the cross section on table <TECHNICAL
FEATURES> paragraph), always keep the
earth wire longer than the phase wires
and, in addition, follow all the instructions
given in the “ELECTRICAL CONNECTION”
paragraph.
• To replace the oven lamp please refer to
instructions on REPLACING THE OVEN LAMP
paragraph.
• To change the lamp holder, the spark
generator and the spark electrodes, the
work top has to be removed as indicated
in paragraph «REPLACING THE TAPS AND
THERMOSTAT».
• To change the eventual programming
accessory, the commutator and the indicator
lights, remove the front panel as indicated in
paragraph «TAPS»