Instruction for Use

2. INSTALLATION AND PREPARATIONS FOR USE

This modern, functional and practical cooker, that was manufactured with the parts and materials of

highest quality, will meet your cooking needs in every aspect. You must surely read this manual so

that you don't have any problem in future and to be able to have satisfactory results. The following

information are the required rules for right installation and service processes. It must be read

especially by the technician who will install the appliance

Important: This appliance must be installed by a qualified people according to the

manufacturers installation instructions, local building regulations, gas authority codes and

electrical wiring instructions.

Your product must be set up and used in a place where it will always have ventilation

While operating, this appliance needs

There must be a natural ventilation enough to provide the gas to be used in the environment.

The average air flow must directly come in through the air holes that will be opened on the walls

that are opened towards outside.

2.1 Environment where your appliance will be installed

• .

• 2m /h air per kw input.

•

These air holes must have at least the effective cross section of 100cm for fresh air circulation

(One or more air holes can be opened.). This hole (or holes) must be opened so that they should

not be blocked. Preferably they must be placed close to the bottom and at opposite side of the

smokes of the burned gases that were emptied. If it seems not possible to open these

ventilations in the place where the appliance is set up, the needed air can also be obtained

through the next room, provided that this place is not a bedroom or a dangerous place. In this

case this “next room” must also be ventilated as required.

Emptying of the Burned Gases from Environment

The cooking appliances that operate with gas, throw the burned gas wastes out directly to the

outside or through the cooker hoods that are connected to the a chimney that opens directly to the

outside. If it seems not possible to install a cooker hood, it is required to set an electric fan on the

window or wall that has access to fresh air. This electric fan must have the capacity to change the air

of the kitchen environment 4-5 times of its own volume of air per hour

Air inlet section

min. 100cm

Air inlet section

min. 100cm

Figure 1

Figure 2