Instruction for Use

EN9
Connect the yellow/green earth wire to the terminal with the symbol .
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw it on the terminal block with the previously removed screw.
Each time the power is connected, the hob performs an automatic check for a few seconds.
If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch
with minimum contact gap of 3mm.
INSTRUCTIONS FOR USE
Control Panel Description
Control panel
Control panel lock
On/O
Cooking zone controls and corresponding display
Quick access
Slider
Power Management/
Timer/Lock function button
“Flexicook model” (when available)
POWER
I N D U C T I O N
3"
. . . . . . . .
Switching the hob ON/OFF
To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays
switch off. All the cooking zones are deactivated.
If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down.
If within 10 seconds of switching on, no function is selected, the hob switches off automatically.
Switching and adjusting cooking zones
POWER
POWER
E
R
Power indicator display
Selected cooking zone indication
Cooking zone positioning
Increase power level
Decrease power level
Slider operation
After switching the hob on, activate the required cooking zone by pressing the corresponding circular button and place the pot on the zone. With the Slider
control it is possible to select the required power level, from min. 0 to max. 9, or booster “P” if available.
To increase the power level, slide your nger on the slider from left to right several times; to decrease it, slide in the opposite direction. Alternatively the “+” and
“-” quick access buttons can be used.
Deactivation of cooking zones
To switch off the cooking zone, press the corresponding “+” and “-” button for more than 3 seconds.
The cooking zone switches off and, if still hot, the letter “H” appears on the zone display.
Control panel lock
This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Lock function button
for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching
off function. To deactivate the control lock, repeat the activation procedure. The luminous dot goes off and the hob is active again.
The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock.