Instruction for Use
17
8
OVEN DOOR REMOVAL
The oven door can be removed to give easier
access to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or nail
(R) in the hole (F) of the hinge (g. E).
• Partially close the door, forcing it upwards at
the same time to free stop tooth and hinge
sector.
• Once the hinge is free, pull the door forwards
tilting it slightly upwards to free sector.
• To reassemble proceed in the reverse order,
paying attention to the correct position of
sectors.
REPLACING THE OVEN LAMP (g. 8)
Ensure the appliance is switched o before
replacing the lamp to avoid the possibility
of electric shock.
IIn the event one or both oven lamps need
replacing, the new lamps must comply with the
following requisites: 15 W - 230 V~ - 50 Hz - E
14 - and must be resistant to high temperature
(300°C).
Draw out the side guide rails as described
above.Then, remove the glass protection
cap (V) from the bulb socket, lifting it with a
screwdriver (C) placed between the cap and
the oven wall and replace the lamp. Fit the
accessories back in reverse order.
The lamp used in the appliance is specically
designed for electrical appliances and is not
suitable for household room illumination
(Commission Regulation (EC) No 244/2009).
OVEN SEAL
The oven seal guarantees the correct
functioning of the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or
is damaged, contact our Service Centre
and avoid using the oven until it has been
repaired.
USER’S INSTRUCTIONS
7