Instruction for Use

24
• with a exible stainless steel, seamless
pipe in accordance with the standard,
with a maximum 2 metre extension and
seals in accordance with the standard. We
recommend applying the special adapter to
the exible pipe, easily found on the market,
to facilitate connection to the pressure
regulator’s hose tting on the cylinder.
• with a flexible rubber hose in accordance
with the standard, with an 8 mm diameter,
minimum 400 mm in length, maximum
1500 mm in length, firmly secured to the
hose fitting with a safety clamp as per the
standard.
ATTENTION:
• If the appliance is going to be recessed
(class 2 subclass 1), connect it to the gas
supply source using only exible stainless
steel, seamless pipes in accordance with
the standard.
• If the appliance is going to be installed
free-standing (class 1) and if you use
the exible rubber hose, it is necessary
to follow the instructions and the g. 14
given below:
• On its route, the hose must not touch any
parts where the over temperature is than
95°C.
• The hose must not be subject to any kind
of torsional stress or tractive force, there
must be no pinched parts or really sharp
bends.
• It must not touch anything that can cut,
that has sharp corners, etc.
• The whole length of the hose must be
easy to inspect in order to keep a check on
its condition.
• It must be replaced within the date
printed on it.
INSTRUCTIONS FOR THE INSTALLER