Instruction for Use

17
L
C
PL
L
P
S
S
L
PL
L
P
S
S
L
D
V
12
OVEN SEAL
The oven seal guarantees the correct
functioning of the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or
is damaged, contact our Service Centre
and avoid using the oven until it has been
repaired.
SELF-CLEANING PANELS (Depending of
the model)
Oven walls are protected by panels coated with a
grease-proof, microporous enamel that absorbs
and eliminates splattering during baking.
If there is a lot of liquid or grease, dry
immediately with a damp sponge and heat the
oven for 2 hours on the maximum thermostat
position. Wait for the oven to cool down and
then go over it again with a damp sponge. If
you are unable to remove all the substances,
repeat the above procedure.
It is, however, advisable to periodically remove
the panels and wash them with warm soapy
water and dry them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the
previous paragraph.
• Remove both side panels (PL) (g.11).
• Remove back panel by unscrewing
respective locking screws (V) (g.12).
• Repeat previous operations in reverse order
to replace all elements.
IMPORTANT!! Position both side panels (PL)
by taking the locking pin (L) out of the hole (S)
(g.11).
USER’S INSTRUCTIONS
11
OVEN SIDE GUIDE RAILS
For an eective cleaning of the oven side-guide
rails, these can be extracted unscrewing the
screws which hold the washers (A).
To t the rails back in their place, x the screws
and the washers with screwdriver
10