Instruction for Use

25
INSTRUCTIONS FOR THE INSTALLER
B
D

B
A
A
C
X
X
A
B
C
B
A
D
D
22
23
24
OVEN BURNER (g. 22)
The burner is installed on the oven base and is
covered by the bottom plate which must always
remain in that position during oven operation,
To adjust the primary air, light the burner
and, watching the ame, slacken screw (A)
and adjust sleeve (B) to obtain the X openings
indicated in the table <TECHNICAL FEATURES>
paragraph Lock screw (A) in place once the
adjustments have been made.
GRILL BURNER (g. 23)
To adjust the primary air, light the burner
and, watching the ame, slacken screw (A)
and adjust sleeve (B) to obtain the X openings
indicated in the table <TECHNICAL FEATURES>
paragraph Lock screw (A) in place once the
adjustments have been made.
CONVERSIONS
REPLACING THE INJECTORS
Our burners can be adapted to dierent
types of gas by simply installing the injectors
suitable for the gas you want to use. To help
the installer, the table <TECHNICAL FEATURES>
paragraph gives the burner nominal heat input,
injector diameter and operating pressure of the
dierent gas types.
Comply with the following instructions:
Injector replacement - Hob burners.
To change the injectors on the hob, remove the
burner cup and head and with a 7 mm Ø socket
spanner replace them (g. 24).
Injector replacement - Oven burner.
Remove oven base. Remove screw (D) which
will release burner and give access to the
injector (C)
(g. 22). Unscrew injector and replace it.
Replace burner and replace screw (D).
Injector replacement - Grill burner.
Remove screw (D) which will release burner
and give access to the injector (g. 23).Unscrew
injector (C) and replace it. Replace burner and
replace screw (D).
After having replaced the injectors, it
will be necessary to proceed with burner
adjustment as explained in the previous
paragraphs. The technician must replace
any seals after the adjustments have been
made.