Dehumidifier User manual

1. To remove outer cabinet:
a. Disconnect power cord.
b. Take off the front plastic grille. Remove the
two screws at the bottom. Drop grille down
and take out.
TOP FLANGE
SOCKET HEAD
II I
SCREWS
/
(slde of cabinet)
c. Remove the cabinet screws on each side
and top flange screws (see illustration). On
30, 40 and 48 pt. models, also remove rear
grille. Pull out at bottom and drop grille
down.
d. Lift cabinet from unit,
2. Coils should be inspected annually Brush clean,
c
if necessary, with warm water and mild de-
6
tergent. Rinse and dry. Be sure power supply
r
c
.
/:
5. The compressor is sealed and needs no oiling.
However, the fan motor should be checked an-
m mllv nnrl nilcrd
(maCK VII Hole
Not Shown)
4. To oil fan motor, place a few drops of a good
grade oil in both oil holes located on the fan
motor. Oil capsules can be ordered [Part No.
10943) from your dealer.
5. Wash plastic parts with a soft cloth, warm water
and mild detergent. Rinse and dry with a soft
cloth.
6. Replace cabinet grille(s). Reconnect power
supply cord.
OIL FAN MOTOR
#m--m- AI. ..-.-
8