Use and Care Manual

ManualsBrandsWhirlpool ManualsHeating, Ventilation, and Air Conditioning70-Pint 2-Speed Dehumidifier, Energy Star

NOTE:

When the light is on. it will remain on for 180 hours or

Filter Monitor

1. When Filter Monitor indicator light is lit, remove, clean and

replace air filter. See “Cleaning the Air Filter”.

2. Press FILTER MONITOR after cleaning and replacing the

air filter. This resets the filter monitor

until you press FILTER MONITOR. After 180 hours, it will turn

off automatically.

Power

Press POWER to turn on or turn off the dehumitifier.

NOTES:

Heat (for heating function model only)

NOTE: The compressor does not operate in the HEAT mode.

1. Press HEAT to select the Heat mode.

will turn off. The fan keeps running.

2.Press FAN to select the fan speed. see “Fan Speed”.

3.Press the Plus or Minus arrow button to select the temperature.

4.To turn off the Heat mode, press MODE or POWER.

■ If the room temperature is above 86 the Heat mode ºF (30 ºC) ,

If the room temperature is higher than the selected 2 ºF (1 ºC) .

■

temperature, the Heat mode will turn off.

■

If the room temperature is lower than the selected 2 ºF (1 ºC)

temperature, the Heat will turn on.

Press both the plus and minus arrow button at same time to

change from . ºF to ºC

drain, out a window or anywhere you think suitable.

with a 16 feet hose included. You can also pump water to a

Pump (for Pump function model only)

This feature can help to pump water horizontally or vertically

IMPORTANT:

You must connect the drain hose to the unit before pressing

Pump button. see “Pump drain” for connecting direction.

Press PUMP to activate the pump system for active drainage.

2. Once the pump button is pressed, the pump light will switch on.

NOTE:

■

If the pump light flashes, it means that the pump is not functioning

properly.

If the drain hose is not correctly connected to the unit or is bent,

the pump light will flash and the pump system will not work.

See “Trouble shooting” for direction.

■

Ionizer (for Ionizer function model only)

1. Press IONIZER to start or stop the ionizer.

2. Once the IONIZER button is pressed the ionzier light will

switch on.

ºF to ºC .

Change from