Instruction for Use

EN -9-
What to do if...
If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.
Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation.
The appliance... Possible causes... Solutions...
...is not working/will not start - The appliance must be switched on. - Check the household circuit fuse if there is no power supply.
- The dishwasher door doesn’t close. - Check if the dishwasher’s door is closed.
- “Delayed start” option is ON.
- Check whether the “Delayed start” option (if available) has been selected. If it has,
the appliance will only start once the set time has elapsed. If necessary, RESET the
appliance by pressing CANCEL or start the cycle immediately by pressing START.
...the CANCEL/Off indicator lamp
blinks 6 times
- Water tap closed. - The water tap must be open.
- Kinked water inlet hose or clogged inlet
filters.
- The water inlet hose must not be kinked and the relative inlet filter in the water
tap connector must not be dirty or clogged.
- Water pressure too low.
- The water tap must be fully open during water inlet (minimum capacity: 0.5 litres
per minute).
...the CANCEL/Off indicator lamp
blinks 6 times/wash program ended
too early (dishes are dirty and wet)
- Dirty or clogged filters. - The filters must not be dirty or clogged.
- Too little water in the dishwasher’s water
system.
- Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack.
- Drain hose incorrectly fitted.
- The drain hose must be fitted correctly (for high mounted appliances, leave min.
200-400 mm from the lower edge of the appliance) - see Assembly instructions.
- High level of foam inside. - Repeat without detergent or wait until foam disappears.
...the CANCEL/Off indicator lamp
blinks 8 times
-Dirty filters. - Clean the filters.
-Kinked drain hose. - The drain hose must not be kinked.
- Syphon hose connection closed. - The closure disk of the syphon hose connection must be removed.
After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated.
RESET: Press the CANCEL/Off button.
Close the door.
Water drains automatically for up to 1 minute.
The appliance is now ready to be restarted.