Instruction for Use

ManualsBrandsWhirlpool ManualsDishwashersADG 4000

-1-

Chart

PROGRAM SELECTION BUTTON

Press button “P” (repeatedly) until the indicator of the required program lights up

(see “Table of programs” below).

BUTTON

OFF

BUTTON

START BUTTON

The indicator lights up during operation, flashes when a fault occurs and goes off at

the end of the program.

START BUTTON RESET FUNCTION

Press this button for at least 2 seconds; the selected program and options are cancelled.

Main failure displays (repeated flashing of the START indicator lamp) can be cancelled

by RESETTING. Detailed instructions are given in chapter “What to do if...”.

(see at right for options description)

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions

(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible

with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Table of programs

Deter-

gent

Consumption

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Pre-Wash cold

— Crockery to be washed later. — 5.0 0.02 10

Quickwash 40°C

—

Lightly soiled crockery, with

no dried-on food.

* Use of tablets not

recommended.

13.0 0.70 30

Eco

50°C

Half

load

Normally soiled crockery.

Energy-saving program.

X 15.0 1.05 165

Intensive 70°C

—

Recommended program for

heavily soiled crockery,

especially suitable for pots

and pans.

X 15.0 1.50 140

5019 396 01880ADG 4000

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE INSTALLATION

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

RINSE AID INDICATOR

When lit, the rinse aid

dispenser needs to be refilled.

SALT INDICATOR

When lit, the salt reservoir

needs to be refilled.

HALF LOAD

The half load cycle can be used for the upper or

lower rack. Select the required program then press

the “Half load” button. The light comes on and

goes off at the end of the programe. This function

can be used with the programs marked with the

relative description in table.

Quick reference guide

Summary of content (8 pages)

PAGE 1
Chart Quick reference guide PROGRAM SELECTION BUTTON Press button “P” (repeatedly) until the indicator of the required program lights up (see “Table of programs” below). ON BUTTON BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE INSTALLATION INSTRUCTIONS! THE GUARANTEE IS NOT APPLICABLE IF FAULTS ARE CAUSED BY INCORRECT USE OF THE APPLIANCE.
PAGE 2
First time use How to set detergent type: powder/gel/tablet (if option is available) In order to always ensure the best cleaning results, you NEED to set: DETERGENT type and WATER HARDNESS. 1. Select 3rd program (see 2. Press START button 3a. Check your Table of programs - page 1) for 7 seconds detergent type... Detergent types Powder or gel (factory setting) 3b....and set it on your dishwasher using the START button (as per table below) 4.
PAGE 3
Daily check Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft”!) 1 Visual indicator (depending on model). Unscrew cap. Add salt (never add detergent!). min. 0.8 kg max. 1 kg Fill the salt reservoir with water before the first wash only. (depending on the model) Salt indicator on the control panel The salt level indicator lamp may remain lit for the duration of several wash cycles.
PAGE 4
How to load the racks How to load UPPER RACK 4 B - Adjustable flaps: In horizontal position for cups/long utensils, in raised position for plates and stemware. (In some models only) A - Multipurpose support: Different positions for long utensils, cups and glasses. How to adjust upper rack height (if available) - It could be useful to lift up upper rack to have more space in lower rack or bring it down to load long stem glasses.
PAGE 5
Select program 6 Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached table of programs (page 1). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. Wash cycle 7 The dishwasher door must be closed and the water tap open.
PAGE 6
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... ...is not working/will not start ...shows “F1” on the display or the START indicator lamp flashes once ...shows “F4” on the display or the START indicator lamp flashes 4 times ...
PAGE 7
What to do if... Crockery and cutlery... ...salt indicator lit ...have deposits: regeneration salt residue ...are not dry Possible causes... Solutions... - Use tablets for soft water. - Set “Detergent type” option; if this option is not available, it is normal for the salt indicator to light up. - Water too hard. - In areas with very hard water, more regeneration salt needs to be added (see page 2 “How to set water hardness”). - Salt reservoir cap open. - Close the salt reservoir cap properly.
PAGE 8
Disconnect the mains plug What to do if... If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the After-sales Service (see warranty). Before contacting our After-Sales Service, take note of the following: - the description of the fault, - the appliance type and model, - the service code (the number indicated on the adhesive rating plate) inside the door on the right-hand side: Precautions and general recommendations 1.