Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADG 4554 M

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91203

ADG 4554

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/FD/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

“Delayed start” buttons

The wash cycle can be programmed

to start after 3-6-9 hours.

Then press the Start button.

The wash programme will start at

the set time.

“Half load” button

This function can be used with any

programme. The indicator lamp

switches on. The wash cycle is

activated for the upper

lower rack

only

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions“;

3) Values may vary in relation to usage, e.g.: different loads,

water temperatures - above or below 15°C - as well as water

hardness and power supply voltage, etc.

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Quickwash 40°C

Lightly soiled crockery with no dried-on

food.

X - 10.0 0.65 30

Normal

50°C

Normally soiled crockery. X X 13.0 1.24 128

Normal 65°C

Normally or heavily soiled crockery. X X 13.0 1.45 90

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 14.0 1.70 140

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADG 4554 Options On button “Delayed start” buttons The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time. Off button Programme selection button “Half load” button This function can be used with any programme. The indicator lamp switches on. The wash cycle is activated for the upper or lower rack only.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door, switch on the appliance Press the ON button. Large compartment A: How to fill the detergent dispenser A With each wash cycle. B C Small compartment B: For programmes with pre-wash only. Check the rinse aid level Check the regeneration salt level Load the racks Select a programme Select options Press the Start button Mechanical indicator lamp C.
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Half Load: Load the upper rack only.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • There is a power failure. • Starting the selected programme.