Instruction for Use

EN -1-
Whirlpool is a registered trademark of Whirlpool USA
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the
cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push Start button and close
the door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
6th Sense
Power Clean
40-70°C
Delay
Multizone
Power Clean
Use for normal soiled dishes with dried-on
food. Senses the level of soiling on the dishes
and adjusts the program accordingly. When
the sensor is detecting the soil level an
animation appears in the display and the cycle
duration is updated. The Power Clean option
is activated automatically with this program.
To deactivate, press the Power Clean button
on the control panel.
X 7-14 1.00-1.65 80-165 Full
P2
Pre Wash Cold
Delay
Multizone
Crockery to be washed later.
4.0 0.03 14 NO
P3
Fragile 40°C
Delay
Multizone
Light soiling, for example glasses and cups.
X 10.0 0.85 100 Light
P4
Rapid 45°C
Delay
Multizone
Lightly soiled crockery, with no dried-on
food.
X 11.0 0.80 30 NO
P5
Eco
2)
50°C
Delay
Multizone
Power Clean
Normally soiled crockery.
Energy-saving program.
X 11.0 0.92 240 Full
P6
Fast Daily 60°C
Delay
Multizone
Normally soiled crockery.
X 10.0 1.30 80 Full
P7
Silent 50°C
Delay
Multizone
Normally soiled crockery, gentle and quiet
thanks to the lower spray pressure (39 dBa).
X 13.0 1.20 290 Light
P8
Intensive 65°C
Delay
Multizone
Power Clean
Recommended program for heavily soiled
crockery, especially suitable for pans and
saucepans.
X 14.0 1.60 145 Full
P9
Steam
Delay
Multizone
Power Clean
Program including steam action dedicated for
heavily soiled crockery, pots and pans.
Soaking or hand pretreatment is no longer
needed.
X 14.0 1.70 180 Full
P
10
Hygiene
3)
Delay
Multizone
Power Clean
Normally or heavily soiled crockery, with
additional antibacterial wash. Program
interruption (e.g. due to door opening) can
compromise elimination of germs.
X 13.0 1.50 118 Full
5019 300 00270
Options and display description
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE
CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF
NO CYCLE HAS STARTED.
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to be
refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to
24 hours. With each
press of the button, the
delayed start indicator
increases by one hour
and after 24 restarts from
0. Then press the START
button. The dishwasher
will start after the set
time.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up) if
you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
POWER CLEAN
Thanks to the additional power jets
this option provides a more intensive
and powerful wash in the lower rack,
in the specific area. This option is
recommended for washing pots and
casseroles (see page 4). Press this
button to activate Power Clean (the
indicator lights up).
For non Power Clean loading to
achieve best cleaning performances
and resources optimization, Power
Clean should be switched off.
Quick reference guide

Summary of content (8 pages)