Quick Start Guide

Whirlpool is a registered trademark of Whirlpool USA
5019 396 91515
GB
ADG 8976
Quick Reference Guide
Before using the dishwasher, read the user instructions!
WH/I/K/GB
(We reserve the right to make technical modifications)
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Time and failure display
3)
Indicates in hours the time remaining until the start of
the wash cycle. Switches off when the programme has
started. Toward the end of the programme, during the
drying cycle, the display will indicate the time
remaining in minutes.
“F....” Identification of faults for service technician
“Delayed start” button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button. The
dishwasher will start at the set time.
Antibacterial rinse
4)
This function adds an antibacterial rinse at the end of
the wash cycle, thereby guaranteeing a perfectly clean
and sanitized load. The lamp will light up when the
function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time), the
lamp will start blinking to indicate that sanitation is
not guaranteed.
1) Reference programme for energy label in compliance with EN
50242 regulations;
2) Refer to “User instructions“;
3) Program data obtained in conformity with European standard EN
50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.
4) The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille (France), based on the NF EN 13697 standard of
November 2001.
5) These programmes can be used with the Antibacterial rinse
option.
Programme selector knob
Mains
On / Off
Start button
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end
of the programme.
Indicators
Wash cycle
Pre-Rinse Washing Drying
Programme
end
Options
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B
Litres kWh Minutes
Sensor Normal
5)
40-55°C
Automatic programme recommended for
routine washes, with no dried-on or
burnt food (not for EN 50242).
X X 10.0-13.0 0.80-1.05 60-120
Sensor Intensive
5)
60-70°C
Automatic programme recommended for
heavily soiled crockery with dried-on or
burnt food, for example pans and
saucepans.
X X 13.0-20.0 1.10-2.00 100-150
Pre-Rinse
cold
Crockery to be washed later. - - 4.0 0.03 14
Glass
40°C
Light soiling, for example glasses and
cups.
X - 10.0 0.80 55
Quickwash
40°C
Lightly soiled crockery with no dried-on
food.
X - 10.0 0.65 30
Normal
1) 5)
50°C
Normally soiled crockery. X X 13.0 1.05 145
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.