Instruction for Use

9
ENGLISH
GB
5.3. Functionality
Temperature Blast Chilling (+90 à+3°C)
Select blast chilling by pressing key until S2
and S4 LEDs light up.
v Insert the needle probe into the product.
v Start the cycle by pressing the key.
As soon as the needle probe detects the
temperature of +3°C the blast chilling time is
completed and a preserving cycle is automatically
started: the message on the display,
an intermittent sound for 5 seconds and switch-on
of LED S3 confirm the correct conclusion of the
cycle.
The appearance of the alternating
and messages on the display,
indicates the end of the cycle beyond the
maximum time equal to 90 minutes. Press to
detect the effective time taken.
The visualisation of on the display,
alternated to time value 00.00, means that, at the
end of the MAX. time of 90 minutes, the cycle was
not yet concluded. Wait for “END/OUT” messages
to alternately appear on the display; then, press
to show the effective time taken.
Press to conclude the preservation cycle.
Time Blast Chilling (+90 à+3°C)
Select blast chilling by pressing key until S2
and S5 LEDs light up.
v Set the required blast chilling time using
keys and .
v Start the cycle by pressing the key.
This information appears on the display:
At the end of the set time, the blast
chilling cycle is concluded and the preserving
cycle is automatically started: the display of
“END”, an intermitting 5-seconds sound and LED
S3 that goes on confirm the correct conclusion of
the cycle.
Press to conclude the preservation cycle.
1
3
2 2
1
2