Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADP 4408 WH

Whirlpool is a registered trademark of Whirlpool USA

5019 396 98125

ADP 4408

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/B/GB

(We reserve the right to make technical modifications)

“Delayed start” button

The wash cycle can be programmed to start after

3-6-9 hours. Then press the Start button. The wash

programme will start at the set time.

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions“;

3) Programme data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, options, water temperatures - above

or below 15°C - as well as water hardness and power

supply voltage, etc.

Programme selector knob

ON / OFF button

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 5.0 0.02 10

Quickwash 40°C

Lightly soiled crockery with no dried-on

food.

X - 13.0 0.70 30

Eco

50°C

Normally soiled crockery. X X 19.0 1.05 170

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 17.0 1.65 145

Half Load 50°C

Ideal for washing a half load of lightly or

normally soiled crockery.

X X 13.0 1.00 130

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADP 4408 Options 3) “Delayed start” button Programme selector knob The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time. ON / OFF button Start button Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance How to fill the detergent dispenser Check the rinse aid level Check the regeneration salt level Load the racks Press the ON/OFF button. Large compartment A: With each wash cycle. Small compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions! A B C Mechanical indicator C.
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Long-handled utensils (e.g.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.