Instruction for Use

ManualsBrandsWhirlpool ManualsOtherADP 4502/5/S

WH/II/B/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Press the

/OFF button.

Large compartment

With each wash cycle.

Small compartment

For programmes with pre-wash only.

If using combined action dishwasher

tabs, follow the user instructions!

Mechanical indicator

Electric indicator on control panel (if provided).

On models with water softener

system only.

Mechanical indicator

. Electric

indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Select the desired programme (using the specific button or knob).

The corresponding indicator lamp lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is

then memorised (even in the

event of power failure).

- Only open the dishwasher if necessary

(Warning: beware of hot steam).

- If the appliance is switched off during a

wash cycle, when switched on again it

will resume the cycle from where it was

interrupted.

Only after the START button has switched off: Press the ON/

OFF

button.

All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

Switch on the appliance

How to fill the detergent

dispenser

ABC

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Select options

Press the Start button

“Change programme”

Press the START button for 2 sec. until

the Start indicator lamp switches off;

Select another programme and press

the START button again.

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

Summary of content (4 pages)

PAGE 1
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Press the ON/OFF button. How to fill the detergent dispenser Large compartment A: With each wash cycle. Small compartment B: For programmes with pre-wash only. If using combined action dishwasher tabs, follow the user instructions! Check the rinse aid level Mechanical indicator C. Electric indicator on control panel (if provided).
PAGE 2
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for longhandles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Long-handled utensils (e.g.
PAGE 3
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.
PAGE 4
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADP 4502/5 Indicators Add regeneration salt Programme selector knob Only add regeneration salt immediately before starting a wash programme. Add rinse aid ON / OFF button Start button Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.