Instruction for Use

ManualsBrandsWhirlpool ManualsDishwashersADP 5510 IX

EN -1-

Chart

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to be

refilled.

5019 300 02731

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it

indicates the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.

START/RESUME

BUTTON

Push this button to start the

selected program: the

indicator lights up and goes

off at the end of the

program.

When the door is opened

during a washing cycle, the

cycle is temporarily paused:

the Start indicator blinks.

To resume the cycle close

the door and push Start

button again.

CANCEL/OFF

BUTTON

Push this button to switch off

the control panel.

If pressed when a program

is running it cancels the

program ongoing draining

water for 1 minute (0:01 is

shown into the display).

If pressed when the

dishwasher is switched

off, it drains any possible

liquids from dishwasher

(1 minute process).

DELAYED START

BUTTON

Push the button

(repeatedly) to delay the

start of the program -

delay indicator turns on.

Adjustable from 1 to

24 hours. With each press

of the button, the delay

increases by one hour and

after “h 24” returns to

“h 00”.

When this option is

selected the delay

indicator turns on.

Then press the START

button.

The dishwasher will start

after the set time.

TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used.

Push the Tablet button

for 3 seconds (until the

indicator lights up) if you

are using the combined

detergents in tablet (rinse

aid, salt and deteregent in

1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

PROGRAM

SELECTION

BUTTON

Push “P” button

(repeatedly) until selected

program number is

shown on the display

(P1...Px) - see “Table of

programs” below.

POWERCLEAN

Thanks to the additional

power jets this option

provides a more intensive

and powerful wash in the

lower rack, in the specific

area. This option is

recommended for

washing pots and

casseroles (see page 7).

Press this button to

activate PowerClean

(the indicator lights up).

1/2 LOAD BUTTON

Half load cycle can be

used for the upper or

lower rack.

Select the required

program then press the

“Half Load” button - the

light comes on.

Turns off at the end of the

program.

The “Half Load” option

can be used with the

programs indicated in the

table of programs.

Quick reference guide

Whirlpool is a registered trademark of Whirlpool USA

Summary of content (12 pages)

PAGE 1
Chart Quick reference guide BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS! THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED. WASH TIME DISPLAY Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates the time remaining until program start (h.
PAGE 2
Chart Quick reference guide Table of programs Available options Programs Loading instructions Delay Recommended program for routine 1/2 load PowerClean® washes, with dried-on food. Detergent Consumption Drying Phase Minutes 1) Litres kWh X 7-15 1.00-1.70 70-172 Full P1 Sensor P2 Pre-Wash cold Delay Crockery to be washed later. — 4.0 0.01 14-16 NO P3 Rapid 45°C Delay Lightly soiled crockery, with no dried-on food. X 11.0 0.
PAGE 3
First time use How to set water hardness in order to always assure the best cleaning results Water hardness should be set only before the first wash or if water hardness has been changed. - Water hardness level is factory set for medium-hard water (level 4). 4 1 9 1. Ask your water supply company what the water hardness is... German degrees °dH Detergents 10 Press and hold together PROGRAM Selection and CANCEL/Off buttons for minimum 3 seconds.
PAGE 4
Daily check Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulator. 2 Visual indicator If required, open the cover B (press the dedicated button). Check the rinse aid indicator to check the level into the dispenser. The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the button to open the cover B.
PAGE 5
How to load the racks Cutlery rack 4 Long tools can be loaded in the frontal part of the rack (if long tools do not fit in the cutlery rack they can be placed on foldable flaps in upper rack). Load long knives with the handle in the left side. How to remove cutlery rack (if available) - It could be useful to remove cutlery rack to load stem glasses in upper rack. - Open the two retainers (H) to take off the rack. When the cutlery rack is in place the retainers must always be closed.
PAGE 6
How to load the racks Upper rack 4 In the upper rack you can load glasses, cups, bowls and, in the right side of the rack, you can load the dessert dishes. Foldable flaps (A) when open help to load stemmed glasses, long tools or coffee cups. Plate holders (B) can be folded down to load bowls.
PAGE 7
How to load the racks Lower rack 4 In the lower rack plates and pots can be loaded. Vertical plate holders (E) can be folded down to create more space to load pots. When the “Half load/Multizone” option is selected the cutlery basket - F (provided in some models) can be placed in the lower rack. F E How to use PowerClean® ® PowerClean uses the special water jets in the rear of cavity to wash more intensively the high dirty items. 5 1.
PAGE 8
Select program 6 Overview of programs The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1). Choose program according to the attached Table of programs (page 2). Duration of the program depends on the external conditions in the apartment, temperature and pressure etc. For hygienic reasons it is recommended to run a high-temperature cycle (e.g. Intensive 65) at least once per month.
PAGE 9
What to do if... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance... Possible causes... Solutions... salt indicator is lit - Salt reservoir is empty. (After refill the salt - Refill reservoir with salt (for more information - see page 3).
PAGE 10
What to do if... Crockery and cutlery... ...are not perfectly clean/have food residues ...have deposits: regeneration salt residue ...are not dry Possible causes... Solutions... - Too little space between dishes (incorrect - Arrange crockery so that items do not touch each other. Concave items arrangement of the concave items in the rack). (e.g. bowls, cups) must be arranged facing downwards in the rack. - Too little detergent; detergent too old or incorrectly stored.
PAGE 11
What to do if... Crockery and cutlery... Possible causes... Solutions... ...have discoloured plastic parts - Tomato/Carrot juice. - Tomato sauce, for example, can lead to discolouring of plastic parts. Powder detergent is recommended as it allows slightly higher doses to be used for improved whitening. Programs with higher wash temperatures should be used. ...opaque glasses, etc. - Dishes unsuitable for washing in dishwashers (porcelain), - Usage of incorrect programs for glasses.
PAGE 12
Precautions and general recommendations 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol . 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. 3. Before using the dishwasher for the first time - The appliance is designed to operate with a minimum ambient temperature of 5°C.