Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADP 5656 WHM

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91118

ADP 5656

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/K/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

“Half load - Multizone” button

Load the upper

lower rack

only

This function can be used with any programme.

Press once = upper rack (the indicator lamp

comes on)

Press twice = lower rack (the indicator lamp

comes on)

Press 3 times = Off (half load function

deactivated).

“Delayed start” button

The wash cycle can be programmed to start

after 3-6-9 hours.

Then press the Start button.

The wash programme will start at the set time.

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions“;

3) Values may vary in relation to usage, e.g.: different loads,

water temperatures - above or below 15°C - as well as water

hardness and power supply voltage, etc.

Program selector knob

Mains

On / Off

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Wash cycle

Pre-Rinse Washing Drying

Programme

end

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse

cold

Crockery to be washed later. - - 4.0 0.03 14

Quickwash

40°C

Lightly soiled crockery with no dried-on food. X - 10.0 0.65 30

Eco

50°C

Normally soiled crockery. X - 10,0 1,30 75

Normal

50°C

Normally soiled crockery. X X 13.0 1.24 128

Normal

65°C

Normally soiled crockery. X X 13.0 1.65 90

Intensive

70°C

Recommended programme for heavily soiled

crockery, especially suitable for pans and

saucepans.

X X 20.0 2.00 125

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADP 5656 Wash cycle Program selector knob Mains On / Off Pre-Rinse Washing Drying Programme end Start button Options Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme. “Half load - Multizone” button Load the upper or lower rack only. This function can be used with any programme.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: How to fill the detergent A With each wash cycle. B C Small compartment B: For programmes with pre-wash only. Check the rinse aid level Check the regeneration salt level Load the racks Mechanical indicator lamp C.
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Half Load: Load the upper rack only.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • There is a power failure. • Starting the selected programme.