Operation Manual

ManualsBrandsWhirlpool ManualsDishwasheradp 734 wh

GB SUMMARY

BEFORE USING THE DISHWASHER

PAGE

PROTECTING THE ENVIRONMENT

PAGE

PRECAUTIONS AND GENERAL RECOMMENDATIONS

PAGE

ENERGY AND WATER SAVING TIPS

PAGE

HOW TO FILL THE SALT CONTAINER

PAGE

HOW TO FILL THE RINSE AID DISPENSER

PAGE

HOW TO FILL THE DETERGENT DISPENSER

PAGE

CONNECTIONS

PAGE

MAINTENANCE AND CLEANING

PAGE

TROUBLESHOOTING GUIDE

PAGE

AFTER-SALES SERVICE

PAGE

For maximum satisfaction from your dishwasher, carefully read these user

instructions, consult the wash programme chart and the loading guide.

Summary of content (8 pages)

PAGE 1
GB SUMMARY BEFORE USING THE DISHWASHER PAGE 11 PROTECTING THE ENVIRONMENT PAGE 11 PRECAUTIONS AND GENERAL RECOMMENDATIONS PAGE 11 ENERGY AND WATER SAVING TIPS PAGE 11 HOW TO FILL THE SALT CONTAINER PAGE 12 HOW TO FILL THE RINSE AID DISPENSER PAGE 13 HOW TO FILL THE DETERGENT DISPENSER PAGE 13 CONNECTIONS PAGE 14 MAINTENANCE AND CLEANING PAGE 16 TROUBLESHOOTING GUIDE PAGE 17 AFTER-SALES SERVICE PAGE 17 For maximum satisfaction from your dishwasher, carefully read these user
PAGE 2
BEFORE USING THE DISHWASHER • • After unpacking, make sure the appliance is undamaged and that the door closes correctly. Do not use the appliance if it is damaged. If in doubt, consult your local retailer. Keep potentially hazardous packaging (plastic bags etc.) out of the reach of children. • • This appliance is designed for use in the home in compliance with its intended purpose.
PAGE 3
HOW TO FILL THE SALT CONTAINER (Not applicable for Australia). Check the water hardness level in your area. Consult your local Water Board or check your last water bill. • • • If the water hardness level exceeds category 1, before using the dishwasher for the first time, fill the salt container and run a wash cycle so that any excess saline solution discharged is immediately removed by the water to prevent corrosion. The pre-rinse cycle is not sufficient for this purpose. Check the salt level regularly.
PAGE 4
HOW TO FILL THE RINSE AID DISPENSER The rinse aid facilitates drying and prevents the formation of unsightly spots and streaks on crockery. Before using the dishwasher for the first time, fill the rinse aid dispenser. Thereafter, regularly check the rinse aid level. Only use rinse aids recommended for use in domestic dishwashers. 1. Open the rinse aid dispenser by turning knob A counter-clockwise (see diagram) and pulling it out. 2. Fill with rinse-aid until the visual indicator B turns dark. 3.
PAGE 5
CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. • The inlet hose must be securely clamped to the water tap to prevent leaks.
PAGE 6
CONNECTIONS 1) ELECTRICAL CONNECTIONS “Warning - this appliance must be earthed” This appliance is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below.
PAGE 7
MAINTENANCE AND CLEANING Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug. 1. Clean the appliance exterior with a neutral detergent. Do not use abrasive detergents. 2. Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residues. If the spray nozzles become clogged with food residues (clean the spray arms as follows). 1. Unscrew the securing wing-nuts. 2. Remove the spray arms. 3. Clean them under running water. 4.
PAGE 8
TROUBLESHOOTING GUIDE If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem. Restart the wash programme to see if the fault repeats: • Press the On/Off button or push and pull the program knob to restart the programme. If the malfunction persists, switch off the appliance and turn off the water tap. Call our After-Sales Service.