User Manual and Operating Guide

The dishes were not
loaded correctly .
See notes in " Load ing the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that th e sp ay can rotate freely .r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft wate r and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immedia tely after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touc h. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerful enough.
Not enough detergent
was dispensed.
Items are blocking
the path of spray arms.
The filter combination
inthebaseofwash
cabinet is not clean or
is not correct ly fitt ed.
This may cause
the sp ay arm jets
to get blocked.
r
Combin ation of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wrong progra m
has been selected
Use o f cutlery with
a low-quality coating
Error Codes
Tap is not opened, or water intake is restricted,or water pressure
is too low .
Malfunction of temperature sensor or of heating element.
Too mu c h i nle t w ater.
Short circuit or break of temperature sensor
Open circuit or brea k of temperature senso r
Long er inlet time.
Longer heating time,
but not reaching required temperature
Overfilled.
Failure of temperatu re sensor
Failure of temperatu re sensor
When some malfunctions come on, the applian c e will display error codes to warn you:
WARNING!
If overflow occurs, turn off the main water supply before callin g a service.
If there is water in the base pan because of an overfill or small leak ,
the water should be removed before restarting the dishwasher .
20
Uns a ti s
-factory
was hin g
res u lt
Uns a ti s
-factory
dry i ng
res u lt