Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADP 7562 WH

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91158

ADP 7562

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/K/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

Time and failure display

Indicates in hours the time remaining until

the start of the wash cycle. Toward the end

of the programme, during the drying cycle,

the display will indicate the time remaining

in minutes.

“F ....” Identification of faults for service

technicians

“Delayed start” button

The wash cycle can be programmed to start

after 1-24 hours. With each successive

touch of the button, the delayed start

indicator increases by 1 hour, and after

24 returns to 00. Then press the Start

button. The dishwasher will start at the set

time.

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions“;

3) Values may vary in relation to usage, e.g.: different loads,

water temperatures - above or below 15°C - as well as water

hardness and power supply voltage, etc.

Programme selector knob

Mains

On / Off

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Wash cycle

Pre-Rinse Washing Drying

Programme

end

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse

cold

Crockery to be washed later. - - 5.0 0.02 10

Quickwash

40°C

Lightly soiled crockery with no dried-on

food.

X - 13.0 0.70 30

Eco

50°C

Normally or heavily soiled crockery. X X 16.0 1.24 133

Normal

65°C

Normally soiled crockery. X X 16.0 1.65 90

Intensive

70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 22.0 2.15 125

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADP 7562 Wash cycle Programme selector knob Mains On / Off Pre-Rinse Washing Programme end Drying Start button Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme. Options Time and failure display 3) Indicates in hours the time remaining until the start of the wash cycle.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: How to fill the detergent A With each wash cycle. B C Small compartment B: For programmes with pre-wash only. Check the rinse aid level Check the regeneration salt level Load the racks Mechanical indicator lamp C.
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Half Load: Load the upper rack only.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • There is a power failure. • Starting the selected programme.