Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasheradp aquasense

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91558

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/B/GB

(We reserve the right to make technical modifications)

ADP

AquaSense

Add regeneration salt

Only add regeneration salt immediately before

starting a wash programme.

Add rinse aid

Time and failure display

Indicates in hours the time remaining until the start

of the wash cycle. Switches off when the

programme starts and indicates the time remaining

in hours and minutes.

“F....” Identification of faults for service technician

“Delayed start” button

The wash cycle can be programmed to start after

1 - 24 hours. With each successive touch of the button,

the delayed start indicator increases by 1 hour, and

after 24 returns to 00. Then press the Start button.

The dishwasher will start at the set time.

Antibacterial rinse

This function adds an antibacterial rinse at the end of

the wash cycle, thereby guaranteeing a perfectly clean

and sanitized load. The lamp will light up when the

function is activated. If the temperature is not

maintained during the antibacterial cycle (e.g. if the

door is opened and remains open for a long time), the

lamp will start blinking to indicate that sanitation is

not guaranteed.

“Half Load” button

The half load cycle can be used for the upper and

lower rack. Select the required programme then

press the “Half Load” button. The light comes on

and goes off at the end of the programme.

The “Half Load” function can be used with

programmes marked with an

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions”;

3) Program data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, water temperatures - above or below

15°C - as well as water hardness and power supply

voltage, etc.

4) The bacteria removal efficiency has been tested by the

Institut Pasteur de Lille (France), based on the NF

EN 13697 standard of November 2001.

5) These programmes can be used with the Antibacterial

rinse option.

Programme selector knob

On / Off button

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the end

of the programme.

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 5.0 0.02 10

Quickwash 40°C

Lightly soiled crockery with no

dried-on food.

X - 13.0 0.70 30

Eco

5) (*)

50°C

Normally soiled crockery. X - 13.0 1.35 90

Normal

1) 5) (*)

50°C

Normally soiled crockery. X X 16.0 1.05 120

Normal

5) (*)

65°C

Normally or heavily soiled crockery. X X 16.0 1.65 100

Intensive

70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 17.0 1.90 135

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! ADP AquaSense GB Quick Reference Guide Options Time and failure display 3) Programme selector knob Indicates in hours the time remaining until the start of the wash cycle. Switches off when the programme starts and indicates the time remaining in hours and minutes. “F....” Identification of faults for service technician “Delayed start” button On / Off button The wash cycle can be programmed to start after 1 - 24 hours.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Press the ON / OFF button. Compartment A: Fill the detergent dispenser A With each wash cycle. BC Compartment B: For programmes with pre-wash only. Check the rinse aid level Check the regeneration salt level Load the racks Mechanical indicator lamp C. Electric indicator on control panel (if provided). On models with water softener system only.
PAGE 3
Dishwasher loading instructions and racks provided depending on the model Upper rack: B Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. Glass holder (B): Long-stemmed glasses. Long-handled utensils (e.g. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. A Half Load: C Load the upper rack only. Place the cutlery basket (C), if provided, in the upper rack.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.