Setup guide

LC3000 LAUNDRY READER INSTALLATION
PRINTED OCTOBER 6, 2009
1-8
8 Install wires into the AC terminal block as shown in Figure 1-5,
tighten the screws to 5 - 7 in-lbs., and replace power supply cover.
Ensure 120VAC wiring is confined within power supply
compartment when cover is reinstalled to maintain UL
compliance.
9 Reconnect external AC power.
10 Connect to Network.
The LC3000 provides for both 10/100 Base-T, TCP/IP and RS-485
BbTS network connections.
Once connected, configure the LC3000. See: the LC3000 Laundry Reader Configuration
(page 1-10).)
Line
Ground
Neutral
Figure 1-5 Power
Connections