Setup guide

LC3000 LAUNDRY READER INSTALLATION GUIDE
D OCUMENT 1135 REV 03
PRINTED OCTOBER 6, 2009 1-9
LC3000 LAUNDRY READER CONFIGURATION
The Laundry Reader must be configured to communicate with the BbTS network.
LC3000 DEFAULT CONFIGURATION
• DHCP enabled
• NP (host) IP address assigned by DHCP server
CONFIGURATION METHODS
Configure the LC3000 Laundry Reader to interface with BbTS, using one of three modes:
• Configure LC3000 Reader using front panel (page 1-10)
• Configure LC3000 Reader using RS-232 (page 1-11)
The Reader’s RS-232 can be used to connect to a computer using Hyperterminal
• Configure LC3000 Reader using Telnet (page 1-11)
The Reader can be configured via IP if using Ethernet connections once it is assigned an IP address.