Setup guide

LC3000 LAUNDRY READER INSTALLATION GUIDE
D OCUMENT 1135 REV 03
PRINTED OCTOBER 6, 2009 1-21
Install Whirlpool LCI3030 in Laundry Machine
Stacked dryers require two LCI3030s.
15 Remove the operator console from the machine.
Refer to Whirlpool service manual.
16 Route the 4-conductor cable from the LCM20 into the machine.
If the installation is for a stacked machine, route two cables.
17 Attach female connectors from the hardware kit to the machine end of the 4-conductor cable wires.
Use a strain relief or other means to protect and secure the cable where it enters the machine.
18 Insert the LCI male bullet connectors into the female connectors (white to white, black to black, etc.).
Stacked Machine: the additional two-wire harness must be connected as shown in Figure 1-18. The
second LCI fits into the second, independent circuit board as illustrated.
19 Attach the orange wire female disconnect to the M1 spade lug and the black wire with the female
disconnect to the M2 spade lug on the controller board.
20 Connect the 4-pin Molex to the COIN #1 mating connector on the laundry machine controller board.
21 Use the wire ties and wire tie blocks, included in the hardware kit, to dress the wires.
22 Terminate 4-conductor cable at the LCM20 1 x 4 terminal block.
Be sure terminal block numbers match laundry machine numeric identifiers.
The Whirlpool control board must be configured for the coin drop, in addition to the
configuration for the BbTS host.
1
2
3
4
red
black
white
Whirlpool Advantech Laundry Machine
Laundry Controller
Multiplexer (LCM20)
BELDEN 8723
or equivalent 4-conductor cable
Figure 1-18 Whirlpool/Advantech Single Machine (LCI3030)
white
red
black
green
green
COIN 1
M2