Setup guide

LC3000 LAUNDRY READER INSTALLATION GUIDE
D OCUMENT 1135 REV 03
PRINTED OCTOBER 6, 2009 1-23
All washers and dryers must be defined at the host server before the LWI modules can be
configured. The machine type (washer/dryer), manufacturer, and stack configuration are
included in the host server configuration options.
WIRELESS BRIDGE LE3/BRIDGE INSTALLATION
The LE3/Bridge module must be configured prior to being installed. This requires programming a network
ID and configuring the module as a Bridge.
Configure the LE3/BRIDGE
1 Apply power to the LC3000 Reader and
make sure that it is online.
2 Install the configuration cable (p/n 044-042-
043) into the RJ-12 Jack labeled LWI
CONFIG.
This cable is supplied with the LE3/
BRIDGE.
3 Plug the 22-pin Molex connector into the
mating connector of the Bridge module.
4 The LC3000 will detect the module, and
load the current version of software if
necessary. The top two lines of the display
show the machine ID, software version and
network ID.
The factory default for the network ID and
machine ID is **. If the module has been
assigned previously, the message Already Assigned is displayed. In this case, enter 1 for
yes, to reassign the network ID.
5 Enter the network ID.
Network values are 1 through 6.
6 Press OK.
Figure 1-20 Bridge Connections
Configuration port
Terminate Bridge
patch cable
(Bridge(s)
and LWIs)