Instruction for Use
19
Control panel lock function
This function prevents anyone from inadvertently changing settings.
When this function is enabled, even if a button is pressed the corresponding function is not
activated.
To lock the control panel, press buttons (
7
) and (
3
) simultaneously for about 3 seconds until the
yellow LED lights up (
6
).
To unlock the control panel, proceed in the same way: when the yellow LED switches off the control
panel lock function is disabled.
Alarms
Temperature alarm Indicates that the internal temperature is above -12°C.
The acoustic alarm sounds and the red LED (
8
) blinks.
Press the button (
7
) to mute the acoustic alarm, then select the fast
freeze function and check for any faults.
Prolonged power failure
alarm
Indicates that the internal temperature has risen above -8°C following
a prolonged power failure.
The acoustic alarm sounds, the red LED (
8
) blinks and the digital
display (
2
) blinks indicating the highest temperature reached during the
power failure. Pressing the button (
7
), the digital display shows the
current internal temperature.
Sensor alarm Indicates a temperature sensor fault.
The acoustic alarm sounds, the red LED (
8
) blinks and the digital
display (
2
) shows SF. In these circumstances, contact the After-Sales
Service.
NOTE: The temperature alarm may also activate following the introduction of fresh food; it does
not affect the storage of already frozen food in any way.
The safety of food preservation may be at risk in the event of a power failure. In this case, we
recommend that you check the state of the frozen food.
Energy saving tips
Do not install the appliance in places exposed to direct sunlight or near heat sources.
Do not obstruct the ventilation grille or the air circulation openings.
Remove accumulated dust from the rear of the appliance at least once a year.
Select the correct temperature setting.
Do not place hot food in the refrigerator.
Restrict the number of times you open the lid.
Make sure the ice layer does not build up to more than 5-6 mm thick.
We recommend using the ECO function when small amounts of food are stored.
Changing the lid light bulb
Unplug the appliance from the mains.
Remove the diffuser by following the sequence of steps
shown in the figure.
Unscrew the light bulb and replace it with an identical bulb
of the same wattage and voltage.
Refit the diffuser and plug in the appliance.
3gb33002.fm Page 19 Friday, March 21, 2003 12:12 PM