Instruction for Use

19
INSTALLATION
•
Install the freezer away from heat sources. Installation in a
hot environment, direct exposure to the sun or installation
near heat sources (heaters, radiators, cookers) will increase
power consumption and should therefore be avoided.
•
If this is not possible, the following minimum distances must
be respected:
•
30 cm from coal or paraffin stoves;
•
3 cm from electric and/or gas stoves.
•
Install the freezer in a dry, well-ventilated place.
•
Clean the interior (see "How to clean and defrost the
freezer").
•
Fit the accessories.
•
Fit the spacers (
Fig. 1
,
2
or
3
, depending on model).
Electrical connection
• Electrical connections must be made in accordance with
local regulations.
•
Voltage and power consumption are indicated on the rating
plate inside the appliance.
•
Regulations require that the
appliance is earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property resulting
from failure to observe the above procedures and
reminders.
•
If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
•
Do not use extension leads or adaptors.
Disconnecting the appliance
Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located
upline from the socket.
Fig.1
Fig.2
Fig.3
3gb33000.fm5 Page 19 Thursday, February 8, 2001 9:30 AM