Instruction for Use

AKG668 Installation & Instructions for Use
22
BEFORE YOU START
INSTALLATION INSTRUCTIONS
This appliance is designed for
installing ONLY at a low level, ie.
under a worktop, and it should not
be installed at a high level.
There are three methods for
installing the AKG668.
METHOD 1
Into a space between two base
units, i.e. WITHOUT a housing
unit.
METHOD 2
Into a housing unit, with an
internal height of L E S S t h a n
710mm which can be modified to
obtain the required dimensions.
METHOD 3
Into a housing unit, with an
internal height of 710mm or more.
Look at the different ways the
appliance can be installed, on the
following pages, and plan the
installation to suit your situation.
Leave the appliance in the base
tray packaging until you are ready
to install it. Be careful, when you
remove the appliance from the
base tray packaging, not to
damage the outer frame trim.
FIXING SCREWS
The fixing screws are in a
polythene bag in the oven pack.
Depending on the method of
installation, some of the screws
may not be needed.
Quantity
6 Silver
No 8 x 12mm
Self Tapping Screw
Runners to Appliance
Runners and Side
Trims to Cabinet or
Appliance to Cabinet
Appliance to Side
Trims
No 8 x 12mm
Chipboard Screw
No 8 x 25mm
Chipboard
No 8 x 12mm
Self Tapping Screw
Black
Silver
Silver
12
2
2
Colour Description For Fixing
17485 00 AKG668 Inst. Book 7/10/05 11:25 am Page 24