Instruction for Use

AKG668 Installation & Instructions for Use
25
METHOD 2 Housing unit (internal
height less than 710mm)
NOTE:
You will N O T need the 2 side
trims (692mm long) or the
appliance runners for this
installation.
BEFORE YOU START
Make sure before removing the
bottom support shelf, or modifying
the housing unit that it will remain
structurally sound, e.g. by fixing to
adjacent cabinets, floor, or
worktop.
You may have to cut into or move,
any rear cross members of the
cabinet to obtain the 5 5 0 m m
minimum DEPTH.
To obtain the required 7 1 5 m m
HEIGHT, you may have to lower
or remove the bottom support
shelf, remove any cross rails, and
reposition brackets.
FIX THE RUNNERS:
1. Take one of the side trims, hold
it against the side of the housing
unit, and use it to mark off 692mm
from the top edge of the side unit,
to the TOP EDGE for the runner.
NOTE:
This ensures a 5mm to 8mm
clearance from the underside of
the worktop to the top of the
appliance.
2. Measure 50mm from the front
edges of the base unit, to mark
the front edge for the runners.
3. Take 6 of the No.8 x 12mm
(Black) chipboard screws and
screw the runners into position the
RIGHT WAY up as shown.
4. If necessary, adjust the height
of the plinth to just below the
bottom edge of the runners.
CONNECTION TO THE
ELECTRICITY SUPPLIES
See page 3.
INSERT THE APPLIANCE
Ensure that appliance is engaged
over the top of the side runners.
SECURE APPLIANCE INTO
POSITION
Open the grill door and secure
appliance into position, using the
2 No.8 x 25mm (Silver) chipboard
screws through the front frame,
ensuring that the appliance is
centrally located. Take care not to
damage the outer frame trim on
the appliance.
17485 00 AKG668 Inst. Book 7/10/05 11:25 am Page 27