Instruction for Use

AKG668 Installation & Instructions for Use
27
METHOD 3. Housing unit
(Internal height 710mm or more.
NOTE:
You will NOT need the 4 runners
and 2 trims, that are packed with
the oven for this installation.
Remove any fixings, that may
prevent entry of the oven into
housing. The cabinetry should be
kept structurally sound by fixing to
adjacent cabinets, floor, or
worktop.
When installed in a typical 600mm
deep, built in housing unit, the
false back should be removed
from the housing unit to provide
the necessary depth for
installation.
When the false back is removed,
it is normally the case that the
support shelf for the appliance
leaves a gap between the back
edge of the support shelf and the
wall of approximately 80mm. See
illustration on next page.
Method 3 With Housing Unit
Min.
550mm
560-570mm
712mm
697mm
6mm
Min.
710mm
541mm
9mm
17485 00 AKG668 Inst. Book 7/10/05 11:25 am Page 29