Instruction for Use

N C
M Y
INSTALLATION
Technical information for the installer
This cooking hob can be embedded in a
worktop 20 to 50 mm thick. If another
appliance is not fitted under the cooking hob,
insert a separator panel, at a distance of at
least 20 mm from the cooking hob bottom.
Note: before installation, make sure that the
local gas delivery conditions (type and pressure
of gas) are compatible with the settings of the
cooking hob, as indicated on the rating plate.
x If a vertical piece of furniture is installed,
there must be a gap of at least 100 mm
between it and the edge of the cooking
hob.
x Before installing the cooking hob, remove the
plastic film that protects it, if present.
The outer surfaces of the furniture or appliances
adjoining the cooking hob must be heat resistant
(heat protection “Y”,accordingtolocal
standards).
x Installation must comply with current local
regulations.
x In the room where the cooking hob is installed,
there must be enough air to allow the gas to
burn correctly (see relevant table).
x The natural flow of air must take place through
an adequate opening, that must be:
- permanent, made on one of the outside walls
of the room, and communicating with the exterior
in an area away from sources of pollution;
- built so as to ensure that its openings, both on
the inside and on the outside, cannot be
obstructed, intentionally or accidentally;
- protected by a metal grid or mesh that does
not reduce its working section;
- situated near the floor level and positioned so
as not to interfere with the operation of the fume
exhaust devices.
Assembly
x Apply the supplied gasket to the cooking
hob (unless it has already been fitted), after
having cleaned its surface, as shown in
figure.
To fix the cooking hob, use brackets supplied
with it.
1. Position the brackets on the relevant bores and
fix them by means of their screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
Important: the power supply cable and plug
must be suitable for the power absorption of
the cooking hob, and the cable must be long
enough to permit the upward extraction of the
cooking hob.
16