3gb66034.
3gb66034.fm Page 13 Wednesday, May 28, 2003 5:50 PM BEFORE USING THE COOKING HOB To get full satisfaction of your cooking hob, please read these instructions carefully and keep them for future consultation. Keep the packaging material (plastic bags, polystyrene parts, etc.) out of the reach of children, as they are potentially dangerous. Check whether the cooking hob has been damaged during transport.
gb66034.fm Page 14 Wednesday, May 28, 2003 5:50 PM Declaration of conformity This cooking hob is suitable for contact with foodstuffs, and complies with EEC Directive 89/109. This cooking hob (class 3) has been designed to be used only for cooking. Any other use (such as heating a room) is improper and dangerous.
3gb66034.fm Page 15 Wednesday, May 28, 2003 5:50 PM CARE AND MAINTENANCE Cleaning the cooking hob surface, panstand grids and control panel Before cleaning the cooking hob, disconnect it from mains power supply and wait until it has cooled down. Wipe with a cloth moistened with hot water and soap or diluted liquid detergent. Do not use abrasive or corrosive products, chlorine products or steel wool. Do not leave acid or alkaline substances, such as vinegar, salt or lemon juice, etc.
3gb66034.fm Page 16 Wednesday, May 28, 2003 5:50 PM TROUBLESHOOTING GUIDE 1. The burner fails to ignite: Is the main gas delivery valve open? Has the delivery of the town gas (methane) been suspended? Is the gas cylinder (liquid gas) empty? Are the openings of the burner clogged? Have the cap and burner been positioned correctly after cleaning? (See paragraph Care and maintenance.) 2.
3gb66034.fm Page 17 Wednesday, May 28, 2003 5:50 PM INSTALLATION Technical information for installer This cooking hob can be embedded in a worktop 20 to 50 mm thick. If there is no oven beneath the cooktop (any oven installed must be manufactured by us and equipped with a cooling system), insert a separator panel at a minimum distance of 20 mm from the bottom of the cooktop.
3gb66034.fm Page 18 Wednesday, May 28, 2003 5:50 PM INSTALLATION Electrical connection must be made before connecting the appliance to the electricity supply. The appliance must be installed by a qualified technician who is fully aware of current safety and installation regulations. Specifically, installation must be carried out in compliance with the regulations of the local electricity supply company. Make sure that the voltage indicated on the rating plate corresponds to the voltage in your home.
3gb66034.fm Page 19 Wednesday, May 28, 2003 5:50 PM INSTALLATION Replacing the injectors (see table in enclosed product description sheet) 1. Remove grids A. 2. Extract burners B. 3. Using a socket spanner of the appropriate size, C, unscrew the injector to be replaced. 4. Replace it with the injector suitable for the new type of gas. 5. Re-assemble the injector in D. 6. For models equipped with a triple crown burner, proceed as shown in figure.
Ecological Paper 3gb66034.fm Page 20 Wednesday, May 28, 2003 5:50 PM Printed in Italy 1/0603 5019 319 66034 FR GB 1.002.94.
