Instruction for Use

40
Care and maintenance
Troubleshooting guide
The induction glass ceramic
hob is not working:
 Have you pressed the control
buttons following the
instructions in the section
using the hob?
 Is the power on?
 Have you carefully dried the
hob after cleaning it?
1. If a cooking zone has been
selected and an F,
appears on the display
contact the After Sales
Service and inform them.
2. If one of the following
codes is displayed when the
hob on button is pressed:
E -13 E-22 E-27 E-28 E-29
contact the After Sales
Service and give them the
code.
3. If the booster does not
work, the temperature
inside the hob is too high.
Wait a few minutes until
the cooking zone cools off
or continue cooking
without the booster (max.
level 9).
Cooling fan
The hob is equipped with a
cooling fan which runs at
two speeds, depending on
the temperature in the
hob. If the hob reaches a
level which exceeds the
power of all the hot plates,
it is automatically reduced,
or if necessary, the entire
hob is deactivated. After a
certain period of time, the
hob automatically returns
to the selected
temperature.
Important!
If you are not able to turn
the induction glass ceramic
hob off after using it,
disconnect it immediately
from the power supply.
 Use a clean cloth, kitchen
wipes, washing up liquid,
specific products or the
supplied scraper tool.
 Do not use abrasive
powders or detergents,
surface cleaning sprays,
spot or rust removers,
bleach, sponges with
abrasive surfaces, or iron
pan scourers.
 Clean the hob if possible
after every use, when it is
still warm or after it has
cooled.
Important
Periodically check for dust
under the appliance, near the
cooling air inlet or the outlet
openings. This could hinder
the ventilation and cooling of
the electronic module and
decrease the effectiveness of
the hob.
4gb61581a.fm5 Page 40 Friday, February 28, 2003 2:25 PM