Operation Manual

19
Removing the oven door (for cleaning)
1.
Open the oven door.
2.
Press hinge catches (
A
) forwards.
3.
Lift the catches until they engage and then
remove the door.
4. Warning: While you are cleaning the oven,
ensure you do not disengage the hinge
retainer catches.
5.
Refit the oven door by following the above
steps in reverse order.
Dropping the grill element to clean the oven
roof (depending on model)
•
Do not attempt to clean the oven until it is
cool.
1.
To clean the oven roof, pull out the grill
element and lower it as far as it will go.
2.
Clean the oven roof and then return the grill
element to its original position.
Changing the oven lamp
1.
Disconnect the oven from electrical supply.
2.
Unscrew the lamp cover.
3.
Change the lamp (see N.B.).
4.
Refit the lamp cover.
5.
Reconnect the electrical supply.
Changing the lateral lamp (depending on
model)
1.
Disconnect the oven from electrical supply.
2.
Remove the left hand side grid.
3.
Use a screwdriver to prize off the lamp cover.
4.
Change the lamp (see N.B).
5.
Reposition the lamp cover and press it
against the oven wall until it clicks into place.
6.
Refit the side grid.
7.
Reconnect the power supply.
N.B:
Use exclusively 25 W, 230 V lamps, type E-14,
T300° C, available from After-sales Service.
.
Oven not working
•
Switch the oven off and then on again to see
if the problem persists.
•
Check for the presence of mains electrical
power.
•
Oven selector on position “0”, ?
•
Check whether you have made the
temperature setting and the function setting.
•
If the electronic programmer display presents
the message “OFF”, press any key
(depending on model) to reset the oven and
then set the clock.
•
Ensure that the mechanical programmer
(depending on model) is set to .
CLEANING THE OVEN AND ITS ACCESSORIES
TROUBLESHOOTING GUIDE
54804-gb.fm5 Page 19 Thursday, April 5, 2001 6:04 PM