GB User and maintenance manual
IMPORTANT SAFETY INSTRUCTIONS These instructions shall also be available on website: docs.whirlpool.eu YOUR SAFETY AND THAT OF OTHERS IS HIGHLY IMPORTANT. This manual and the appliance itself provide important safety warnings, to be read and observed at all times. This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
• When drilling through a wall or the ceiling, pay attention not to damage electric connections and/or pipes. • The ventilation ducts must always discharge to the outside. • Exhaust air must not be vented through a flue used for removal of fumes produced by appliances burning gas or other fuels, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
INSTALLATION After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation. PREPARING FOR INSTALLATION WARNING: this is a heavy product; the hood should only be lifted and installed by two or more people.
SAFEGUARDING THE ENVIRONMENT Disposal of packing The packing material is 100% recyclable and is marked with the recycle symbol and in full compliance with local authority regulations governing waste disposal. . The various parts of the packing must therefore be disposed of responsibly Scrapping the product - This appliance is marked in compliance with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
CLEANING WARNING: - Do not use steam cleaners. - Disconnect the appliance from the power supply. IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it immediately with a damp cloth. • Clean the surfaces with a damp cloth. If very dirty, add a few drops of washing up detergent to the water. Dry with a dry cloth. IMPORTANT: Do not use abrasive sponges or metallic scrapers or scouring pads.
MATERIAL SUPPLIED Take all parts out of their packaging and make sure all the listed components are included. • Hood assembled with motor, metal filters and lamps installed. • Remote control • Assembly template • 4 Plugs 10 X 60 mm • 4 Screws 6 X 70 mm • 4 Screws 4 X 7 mm • 2 Screws 3 X 9 mm • 1 connection flange Ø150 mm INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS WARNING: - Installation or maintenance must be carried out by a qualified technician.
INSTALLATION - ASSEMBLY INSTRUCTIONS WARNING: - Installation or maintenance must be carried out by a qualified technician. Very heavy product; hood handling and installation must be carried out by at least two persons. The instructions below, to be carried out in the order in which they are numbered, refer to the figures (with the same step numbers) given on the last pages of this manual. 1. Remove the hood body from the packaging and carry out the following preliminary procedures: 1.
DESCRIPTION AND USE OF THE HOOD 1. Hood body 6 2. Extraction panel 3 3. Lighting 4. Grease filters 4 5. LED indicator light 7 1 8 6. Wall mounting. 5 7. Extraction panel fixing pins 9 8. Safety sliders 2 9. Remote control REMOTE CONTROL The remote control must be recognized by the hood through the following procedure: Hood and remote control pairing procedure Press the "◄" or "►" button until the remote control shows the symbol Press the middle button "■" for 5 seconds.
1
2
3 4
A A B 5 A A B 6 B B B B B B B
7 8
A B B C C C C C 9 10 C C C C C C
11
Printed in Italy 05/2018 400011260440 GB