Operation Manual

ManualsBrandsWhirlpool ManualsHouseholdakr 441 ix

5019 318 33260

F NL E IGB

INSTALLATION AND USE

For installation: The minimum distance between the support surface of the recipients on the cooking device

and the lowest part of the hood must not be less than 60 cm in the case of electric cookers and 70 cm for gas or

combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be

taken into account. It is advisable to contact a qualified technician for installation.

WARNING: Very heavy product; hood handling and installation must be carried out by at least two persons.

Note on installation and use: Read this manual before installing or using the hood. The Manufacturer declines

all liability for any faults, damage or fires caused by the appliance as a result of failure to observe the instructions

and recommendations given in this manual.

Summary of content (7 pages)

PAGE 1
GB INSTALLATION AND USE For installation: The minimum distance between the support surface of the recipients on the cooking device and the lowest part of the hood must not be less than 60 cm in the case of electric cookers and 70 cm for gas or combination cookers. If the installation instructions for the gas cooker specify a greater distance, this must be taken into account. It is advisable to contact a qualified technician for installation.
PAGE 2
? 4 GB F NL E I 5019 318 33260
PAGE 3
. * only present on some models 5019 318 33260 GB F NL E I 5
PAGE 4
Grease filter Carbon filter V1 O W O O R2 Z X1 V3a Z X3 6 GB F NL E I 5019 318 33260
PAGE 5
SAFEGUARDING THE ENVIRONMENT 1. Packing Packing materials are 100% recyclable and are marked with the recycling symbol .Comply with the local regulations for disposal. The packing materials (plastic bags, polystyrene, etc.) are a potential source of danger and must be kept out of the reach of children. 2. Product This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
PAGE 6
Electrical connection AFTER-SALES SERVICE Before calling the After-Sales Service 1. Check to see if you can fix the problem yourself (see “Troubleshooting Guide”). 2. Switch the appliance off and then on again to check if the problem has been eliminated. 3. If the problem persists, contact the After-Sales Service.
PAGE 7
Extractor hood installation (A): fumes are extracted and expelled to the outside through an exhaust duct fixed to the flange C (bayonet coupling). Always shut off the unused exhaust outlet with the plug D1 provided (if provided- bayonet coupling). Important! In some models, in order to use the rear exhaust outlet B2 the plastic part D2 or D3 must be removed first. Use pliers and a cutter to remove it.