Installation Instructions

5019 318 33246
1. Control panel.
a.
Light switch.
b.
Extraction and minimum extraction speed ON/OFF
switch.
c.
Medium extraction speed switch.
d.
Maximum extraction speed switch.
2. Grease filters.
3. Halogen lamps.
4. Telescopic flue.
Grease filters:
Metal grease filters have an unlimited life
and should be washed once a month
either by hand or in a dishwasher at a
low temperature and with a short cycle.
Washing in a dishwasher can cause
grease filters to turn white, but this in no
way affects efficiency.
a.
press the handle to remove the filter
b.
remove it.
Wash the filter and leave it to dry, proceeding in reverse
order to refit it.
Halogen lamps:
Use a small screwdriver or other
suitable tool to prise off the cover.
Refit (snap on).
Only use 20 W max. (12V-G4)
halogen lamps, taking care not to
touch them with hands.
Active carbon filter
(filter hoods only):
The carbon filter must be cleaned once a month in a
dishwasher at the highest temperature, using a normal
dishwasher detergent. Wash the filters on their own.
After washing, reactivate the carbon filter by drying it in the
oven at 100°C for 10 minutes.
Change the carbon filter every 3 years.
Fitting the carbon filter:
1. Remove the grease filter.
2. Remove the filter holder by turning the knobs 90°.
3. Fit the carbon filter “
i
” in the filter holder “
h
”.
Reverse the above procedure to re-fit the filter holder and
grease filter.
a
b
IF NL E PGBD GR